Tin Multilayer‐Aided SAC305‐Based Lead‐Free Solder Joint Interface with Cu: An Investigation of the Stress Distribution by Finite Element Analysis and Nanoindentation Studies
Authors:
- 8 September 2024
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 26 (22)
Abstract
Two different types of lead‐free solder joints Cu/(Sn3.0Ag0.5Cu)/Cu and Cu/Sn/(Sn3.0Ag0.5Cu)/Sn/Cu have been investigated. Joints are produced following the transient liquid phase like soldering process. The microstructure of different intermetallic compounds (IMCs) present at the joint interfaces, as well as their indentation hardness and elastic modulus, have been investigated and analyzed using scanning electron microscopy (SEM), X‐ray diffraction (XRD) spectroscopy, and nanoindentation. The exact position of different microcracks inside the interfaces has been identified by analyzing the elastic–plastic properties and interfacial toughness of these solder joints. The modulus and hardness of the Sn multilayer‐assisted solder joint interface are found to be 60.08%, and 90.18% higher than those of its non‐layered counterpart, respectively. The finite element analysis (FEA) has been done to estimate and compute stress distributions over the interfacial region. The dislocation mechanics involved in strengthening the joint strength are related to the nature of stress flow; as observed in FEA. It is reconfirmed that the high susceptibility to brittle failure of the non‐layered Cu‐SAC305 solder joints could be avoided by using a Sn interlayer in between the Cu substrates and the SAC305 solder paste.Keywords
This publication has 50 references indexed in Scilit:
- Film failure at earlier and later stages of nanoindentation in static and sliding modesEngineering Failure Analysis, 2023
- Controlling Ag3Sn Plate Formation and Its Effect on the Creep Resistance of Sn–3.0Ag–0.7Cu Lead-Free Solder by Adding Minor Alloying Elements Fe, Co, Te and BiMetals and Materials International, 2020
- Retardation Effect of Tin Multilayer on Sn-3.0Ag-0.5Cu (SAC305)-Based Solder Joint InterfaceJournal of Materials Engineering and Performance, 2020
- On the interfacial phase growth and vacancy evolution during accelerated electromigration in Cu/Sn/Cu microjointsActa Materialia, 2018
- Nanoindentation Stress–Strain for Fracture Analysis and Computational Modeling for Hardness and ModulusJournal of Materials Engineering and Performance, 2018
- Miniaturization of Micro-Solder Bumps and Effect of IMC on Stress DistributionJournal of Electronic Materials, 2016
- Effect of Process and Service Conditions on TLP-Bonded Components with (Ag,Ni–)Sn Interlayer CombinationsJournal of Electronic Materials, 2015
- Studies and correlation among the structural, electrical and gas response properties of aerosol spray deposited self assembled nanocrystalline CuOApplied Surface Science, 2011
- Deformation analysis of lap-shear testing of solder jointsActa Materialia, 2005
- An evaluation of the lap-shear test for Sn-rich solder/Cu couples: Experiments and simulationJournal of Electronic Materials, 2004