Low-Temperature Anodic Bonding for Wafer-Level Al–Al Interconnection in MEMS Grating Gyroscope
- 14 December 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 11 (1) , 19-24
Abstract
In this paper, low-temperature anode bonding technology is used to realize wafer-level Al-Al interconnection in MEMS grating gyroscope. The gyroscope structure was fabricated on silicon by micro machining process. Both Al wiring and Al grating were fabricated by magnetron sputtering. Before bonding, the bonded wafers were treated through Ar plasma. The wafer-level bonding was then performed at 330 °C for 15 minutes under 0.21 MPa with a DC voltage of 1000 V. Acoustic and interfacial tests showed a defect-free Al-Al interconnection. The average bonding strength was as high as 33.94 MPa and the measured resistance was approximate to the theoretical value. The bonded structure was also undamaged under 1500 g acceleration shock. It is concluded that the low temperature anode bonding for wafer-level Al-Al interconnection will further promote the development of MEMS grating gyroscope.Keywords
Funding Information
- National Natural Science Foundation of China (61804137)
This publication has 25 references indexed in Scilit:
- High resolution capacitance detection circuit for rotor micro-gyroscopeAIP Advances, 2014
- A high-resolution displacement sensor based on a grating interferometer with the phase modulation techniqueMeasurement Science and Technology, 2012
- In-plane MEMS-based nano-g accelerometer with sub-wavelength optical resonant sensorSensors and Actuators A: Physical, 2008
- Direct Al–Al contact using low temperature wafer bonding for integrating MEMS and CMOS devicesMicroelectronic Engineering, 2008
- Adhesive Wafer Bonding Using Partially Cured Benzocyclobutene for Three-Dimensional IntegrationJournal of the Electrochemical Society, 2006
- A method to maintain wafer alignment precision during adhesive wafer bondingSensors and Actuators A: Physical, 2003
- A HARPSS polysilicon vibrating ring gyroscopeJournal of Microelectromechanical Systems, 2001
- Micromachined inertial sensorsProceedings of the IEEE, 1998
- Ultrasonic C-scan imaging for material characterizationUltrasonics, 1993
- Thermal and electrical properties of copper-tin and nickel-tin intermetallicsJournal of Applied Physics, 1992