Diversity Pertaining to the Attenuation of the RF Disturbance Suppression Power Line Filters
Open Access
- 6 February 2023
- journal article
- research article
- Published by MDPI AG in Electronics
- Vol. 12 (4) , 821
Abstract
Filters for the suppression of the RF disturbances in power lines are passive; wideband stop filters attenuating common as well as differential disturbances should be insensitive to the variation in the impedance at the input and the output. The design and verification process of such filters differs entirely from that used for the signal RF filters. In the document CISPR 17, entitled “Methods of measurement of the suppression characteristics of passive EMC filtering devices”, two definitions of the attenuation of the common and differential modes are presented. The first is simply direct measurement, and the second is based on a calculation using the single-ended S-parameters of the multiport. These two definitions are the source of diversity. In this paper, we hypothesize that the attenuations achieved with these two methods are identical only if the filter is in perfect balance. Consequently, different attenuations can be achieved. The requirement of balance can be violated due to the tolerances of the components used in the filter. The paper begins with a simple unbalanced four-port, for which analytical formulas are derived. It is also shown that an approach with single-ended S-parameters enables the calculation of the mode conversion between the input and the output, which is called the conversion loss. This is the measure of the grade of the imbalance. Thereafter, the common-mode attenuation of an exemplary RF suppression filter is derived with the presented methods. Additionally, the conversion loss of the filter is calculated. The comparison of the conversion loss with both attenuations is satisfactory, proving the hypothesis formulated in the paper.Keywords
Funding Information
- Institute of Theory of Electrical Engineering, Warsaw University of Technology
This publication has 9 references indexed in Scilit:
- Methods of Assessing the Effectiveness of Filter Elements in Power ElectronicsEnergies, 2022
- Evaluation of the Effectiveness of Ferrite Characteristics Measurements Based on the CISPR 17 StandardIEEE Transactions on Magnetics, 2022
- Reliability Assessment of MV Power ConnectionsEnergies, 2021
- An Elimination Method for an Emergency Situation in Gas-Insulated Switchgear in Power GridsIEEE Transactions on Power Delivery, 2021
- Design of a Fully Integrated EMI Filter for a Single-Phase Grid-Connected InverterIEEE Transactions on Industrial Electronics, 2020
- Adaptation of the Artificial Mains Network (AMN) to the Updated Requirements of CISPR 16-1-2:20142018
- Modeling of a Buck Converter With a SiC JFET to Predict EMC Conducted EmissionsIEEE Transactions on Power Electronics, 2014
- Power-Loss Evaluation in CM Active EMI Filters for Bearing Current SuppressionIEEE Transactions on Industrial Electronics, 2011
- Characterization and Parasitic Extraction of EMI Filters Using Scattering ParametersIEEE Transactions on Power Electronics, 2005