Effect of magnetic-field orientation on electron-density measurement using microwave cutoff probes in weakly magnetized plasma
- 20 October 2026
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (15)
Abstract
In this study, the wave transmission characteristics and cutoff-frequency shift of the microwave cutoff probes were investigated in weakly magnetized plasma using electromagnetic simulations and a magnetized equivalent circuit model. The external magnetic field was varied from 0 to 200 G, and the relative orientation of the electric field between the probe antennas was changed to examine its effect on cutoff-frequency. For the square cutoff probe, the cutoff frequency coincided with the input plasma frequency under parallel configuration, whereas it shifted toward the upper-hybrid resonance frequency under the perpendicular configuration due to electron cyclotron motion. This field-orientation-dependent shift was well described by the magnetized circuit model using the anisotropic dielectric tensor of magnetized plasma, with the electron-density discrepancy remaining within 2% under the parallel and perpendicular configurations and within 3% under oblique-field orientations. The cylindrical cutoff probe showed the same trend and demonstrated valid electron-density measurement capability, although a slightly increased discrepancy was observed under the perpendicular configuration, reaching up to 6%. Electric-field distribution analysis revealed that this difference originates from the more limited effective antenna-to-antenna field region in which the electric field is well aligned with the nominal configuration for the cylindrical probe. Misaligned field components near the antenna tip introduce additional deviation, which becomes more pronounced with increasing magnetic-field strength. Nevertheless, the discrepancy remained within acceptable levels across all investigated conditions, demonstrating that accurate electron-density measurement using microwave cutoff probes remains feasible in weakly magnetized plasma when the relative field orientation is properly considered.Keywords
Funding Information
- Ministry of Trade, Industry and Energy (2410017944)
- Ministry of Trade, Industry and Energy (2410016972)
- Ministry of Trade, Industry and Energy (2410017046)
- Ministry of Trade, Industry and Energy (2410000200)
- Ministry of Trade, Industry and Energy (2410015637)
- Ministry of Science and IC (2710086067)
- Korea Semiconductor Research Consortium (02222140)
- Korea Semiconductor Research Consortium (00235950)
- Korea Semiconductor Research Consortium (00237058)
- Korea Research Institute of Standards and Science (KRISS-2026-KP2026-0002)
- Korea AeroSpace Administration (RS-2026-25570511)
- Korea Institute of Fusion Energy (EN2642-12)
- Korea Institute of Fusion Energy (EN2643)
This publication has 45 references indexed in Scilit:
- Plasma etching of the trench pattern with high aspect ratio mask under ion tiltingApplied Surface Science, 2022
- Simulation of cold magnetized plasmas with the 3D electromagnetic software CST Microwave Studio®EPJ Web of Conferences, 2017
- Review on high current 2.45 GHz electron cyclotron resonance sources (invited)Review of Scientific Instruments, 2010
- Wave cutoff method to measure absolute electron density in cold plasmaReview of Scientific Instruments, 2004
- Electron cyclotron resonance plasmas and electron cyclotron resonance ion sources: Physics and technology (invited)Review of Scientific Instruments, 2004
- The hairpin resonator: A plasma density measuring technique revisitedJournal of Applied Physics, 2004
- Modeling of magnetically enhanced capacitively coupled plasma sources: Ar/C4F8/O2 dischargesJournal of Applied Physics, 2004
- Plasma frequency measurements for absolute plasma density by means of wave cutoff methodApplied Physics Letters, 2003
- Behavior of atomic radicals and their effects on organic low dielectric constant film etching in high density N2/H2 and N2/NH3 plasmasJournal of Applied Physics, 2002
- Inductively coupled plasma application to the resist ashingThin Solid Films, 2001