Effects of water boiling, microwave, and water bath post-polymerization on mechanical properties of acrylic denture resins
Open Access
- 1 January 2018
- journal article
- research article
- Published by National Library of Serbia in Hemijska industrija
- Vol. 72 (3) , 129-137
Abstract
Acrylic restorations in the mouth are exposed to strong occlusal forces. Their mechanical properties depend on the type and method of their polymerization. The aim of this study is a comparative analysis of mechanical properties (flexural strength and modulus of elasticity) of acrylic materials before and after the post-polymerization treatments (water boiling, microwave irradiation and water storage). The study included denture base resins, as well as an acrylate for orthodontic appliances impregnated with aesthetic beads. Flexural strength, modulus of elasticity and the deflection were measured immediately after polymerization, after a hot and microwave post-polymerization and after immersion in a water bath at the temperature of 37°C. The applied post-polymerization methods resulted in an increase in flexural strength and modulus of elasticity relative to the initial values for all tested materials. Being aware of the reduction in fracture risk of dental prosthesis after a proposed post-polymerization procedure, it could be used in all clinical situations where there is an increased risk of damage to dentures.Keywords
This publication has 39 references indexed in Scilit:
- The effects of thermocycling on the flexural strength and flexural modulus of modern resin-based filling materialsDental Materials, 2006
- Minimization of the inevitable residual monomer in denture base acrylicDental Materials, 2005
- Effects of water storage of E‐glass fiber reinforced denture base polymers on residual methyl methacrylate contentJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2004
- Techniques for reducing residual monomer content in polymers: A reviewPolymer Engineering & Science, 2002
- The effect of preparation conditions of acrylic denture base materials on the level of residual monomer, mechanical properties and water absorptionJournal of Dentistry, 1995
- Residual monomer content and its release into water from denture base materialsDental Materials, 1995
- Effect of the curing cycle on residual monomer levels of acrylic resin denture base polymersJournal of Dentistry, 1992
- Leachability of denture-base acrylic resins in artificial salivaDental Materials, 1990
- Comparison of three- and four-point flexural strength testing of denture-base polymersDental Materials, 1989
- A review of the properties of some denture base polymersJournal of Dentistry, 1980