Effect of Processing Temperature on the Thermal and Mechanical Properties of BPDA–PDA
Authors:
- 30 May 2022
- journal article
- research article
- Published by Pleiades Publishing Ltd in Polymer Science, Series B
- Vol. 64 (4) , 518-525
Abstract
High heat resistant and stable dimensional PI films have been widely used in organic light emitting diode industry, therefore the comprehensive performance should be enhanced. The PI films of low CTE and high heat resistance were prepared with 3,3′,4,4′-biphenyltetracarboxylic dianhydride (BPDA) and p-phenylenediamine (PDA) under different processing conditions. WAXD and FTIR were performed to characterize the microstructure of the films. DMA and TMA were conducted to investigate the mechanical and thermal properties of the films. The results showed that the density of the films increased and water absorption rate decreased with fabrication temperature as a result of the smectic structure. The smectic structure of the film attributed to the oriented polymer chains was observed in the DMA curves peaked at 470°C. The film would shrink at round the glass transition temperature as indicated by the TMA curves when it was prepared at relatively lower fabrication temperature, resulting in a larger CTE value compared with other prepared at high fabrication temperature. The 1% weight loss temperature increased with the fabrication temperature for the smectic structure. The tensile strength and elongation at break of the film increased with smectic density. The heat resistance and mechanical performance of bioriented films were the best among all the samples as the PI chains were stretched during the imidization process when all the edges of the film were fixed. The results obtained in this paper could offer practical and valuable references to optimization of processing parameters for the preparation of high performance PI films.Keywords
This publication has 15 references indexed in Scilit:
- Advanced polyimide materials: Syntheses, physical properties and applicationsProgress in Polymer Science, 2012
- Colorless Polyimide/Organoclay Nanocomposite Substrates for Flexible Organic Light-Emitting DevicesJournal of Nanoscience and Nanotechnology, 2010
- Spontaneous molecular orientation of polyimides induced by thermal imidization (4): Casting- and melt-induced in-plane orientationEuropean Polymer Journal, 2010
- Effects of monomer structure and imidization degree on mechanical properties and viscoelastic behavior of thermoplastic polyimide filmsEuropean Polymer Journal, 2006
- High strength electrospun polymer nanofibers made from BPDA–PDA polyimideEuropean Polymer Journal, 2006
- Copolyimide imidization induced by far-infrared radiationJournal of Polymer Science Part B: Polymer Physics, 2005
- Flexible Organic Electroluminescent Devices Based on Fluorine-Containing Colorless Polyimide SubstratesAdvanced Materials, 2002
- Ultrathin glass for flexible OLED applicationThin Solid Films, 2002
- Dependence of water sorption in polyimides on the internal linkage in the diamine componentPolymer Degradation and Stability, 2001
- Effects of precursor structure and imidization process on thermal expansion coefficient of polymide (BPDA/PDA)Polymer, 1997