Effect of particle volume fraction on wear behavior in Al–SiC MMC coated on DIN AlZnMgCu1.5 alloy
- 29 January 2024
- journal article
- research article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 66 (4) , 553-566
Abstract
In this study, DIN AlZnMgCu1.5 alloy surface (Al + SiC) was coated with metal matrix composite (MMC) by using hot press sintering method (HPSM). Al was used as matrix material and SiC powders were used as reinforcing material in the coating process on DIN AlZnMgCu1.5 alloy surface. Al/SiC MMC coating was produced at 600 °C under 120 MPa pressure and with varying SiC content (5, 10 and 15 vol.%). Optical microscopy (OM), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), and X-ray diffraction (XRD) were used to examine the microstructure, elemental analysis and phase structure of both the coating zone and the transition zone between the substrate and the coating. The hardness was measured and a dry sliding linear reciprocating wear test was run to determine the mechanical properties of the coating layer. Consequently, the coefficient of friction (COF) and wear volume were determined. OM and SEM images showed a homogeneous distribution of SiC particles and a less porous structure. The hardness of the MMC coating increased with increasing SiC content. Also, the numerical analysis of the wear test simulation was done based on Archard’s law. The results of both wear tests showed that the volume loss values were consistent with each other and the amount of wear significantly reduced by increasing the rate of SiC reinforcement.Keywords
This publication has 65 references indexed in Scilit:
- Experimental and Simulation Study on Wear Behavior of ZK60 Alloy with 3 wt.% Yttrium AdditionJournal of Materials Engineering and Performance, 2022
- Effect of Sintering Mechanisms on the Mechanical Behaviour of SiC and Kaoline Reinforced Hybrid Aluminium Metal Matrix Composite Fabricated through Powder Metallurgy TechniqueSilicon, 2021
- Microstructural and wear properties of the Al-B4C composite coating produced by hot-press sintering on AA-2024 alloyJournal of Mechanical Science and Technology, 2021
- Dry sliding wear simulation of hybrid aluminum metal matrix compositesAdvanced Composites and Hybrid Materials, 2020
- Improving interfacial, mechanical and tribological properties of alumina coatings on Al alloy by plasma arc heat-treatment of substrateApplied Surface Science, 2017
- A Methodological Approach for Incremental Fretting Wear FormulationTribology Letters, 2016
- Investigation of microstructure and mechanical properties of nano MgO reinforced Al composites manufactured by stir casting and powder metallurgy methods: A comparative studyComposites Part B: Engineering, 2014
- Structural and mechanical behaviour of 5% Al2O3-reinforced Fe metal matrix composites (MMCs) produced by powder metallurgy (P/M) routeBulletin of Materials Science, 2013
- A fuzzy logic based model to predict surface hardness of thin film TiN coating on aerospace AL7075-T6 alloyThe International Journal of Advanced Manufacturing Technology, 2013
- Pre-treatment process of B4C particles to improve incorporation into molten AA2014 alloyJournal of Materials Science, 2007