A simple cavity-enhanced laser-based heater for reflective samples
Open Access
- 1 January 2025
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (1)
Abstract
Surface science instruments require excellent vacuum to ensure surface cleanliness; they also require control of sample temperature, both to clean the surface of contaminants and to control reaction rates at the surface, for example, for molecular beam epitaxy and studies of heterogeneous catalysis. Standard approaches to sample heating within high vacuum chambers involve passing current through filaments of refractory metals, which then heat the sample by convective, radiative, or electron bombardment induced heat transfer. Such hot filament methods lead to outgassing of molecules from neighboring materials that are inadvertently heated; they also produce electrons and ions that may interfere with other aspects of the surface science experiment. Hot filaments may even disintegrate when used in the presence of gases introduced to induce surface reactions on the sample. Optical heating using lasers can deliver energy directly to the sample, ensuring that only the sample is heated and surroundings within the vacuum chamber are not, while simultaneously eliminating the need for hot filaments. Despite this advantage, optical heating is not commonly employed—such methods are considered complex, expensive, and unreliable. More fundamentally, surface scientists are often interested in metallic samples, whose reflectivity may limit the efficiency of laser heating. In this paper, we describe a simple and inexpensive sample heater based on a commercial diode laser, whose heating efficiency is enhanced by a concave aluminum mirror placed behind the sample. The geometry of the reflector and sample ensures that a stable optical cavity is produced. Using only 26 W of laser power directed to the sample with a fiber optic, a 1-cm diameter × 2-mm thick Pt sample could be heated to 1400 K within 1 min. Excellent programmable temperature control and long-term temperature stability are also demonstrated. Sample heating to 900 °C was performed with negligible increase in chamber pressure. The entire setup comprises components costing less than typical electron bombardment heaters.Keywords
This publication has 27 references indexed in Scilit:
- Generation of Sub-nanosecond H Atom Pulses for Scattering from Single-Crystal Epitaxial GrapheneThe Journal of Physical Chemistry A, 2022
- Chemical dynamics from the gas‐phase to surfacesNatural Sciences, 2021
- Silicon emissivity as a function of temperatureInternational Journal of Heat and Mass Transfer, 2020
- Velocity-resolved kinetics of site-specific carbon monoxide oxidation on platinum surfacesNature, 2018
- A brief review of atomic layer deposition: from fundamentals to applicationsMaterials Today, 2014
- Compact laser molecular beam epitaxy system using laser heating of substrate for oxide film growthReview of Scientific Instruments, 1999
- Substrate heater for large area YBa2Cu3Ox films growth without electrical feedthroughsPhysica C: Superconductivity and its Applications, 1994
- Dynamics of adsorption/desorption at solid surfacesSurface Science Reports, 1993
- In situ growth of Y1Ba2Cu3O7−x superconducting thin films using a pulsed neodymium:yttrium aluminum garnet laser with CO2 laser heated substratesApplied Physics Letters, 1991
- Thermal Emission of Alkali Ion Pulses from Clean and Oxygenated TungstenJournal of Applied Physics, 1960