Determination of Stress Intensity Factors under Shock Loading Using a Diffraction-Based Technique
Open Access
- 17 May 2021
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 11 (10) , 4574
Abstract
An experimental optical method has been developed for the measurement of opening and sliding notch face movements. The light passing through a thin slit is monitored by a photodiode detector. Two parts of the slit are fixed independently on the notch faces of the simulated crack. Dynamic variations of the notch face movements are recorded as an electric signal by an oscilloscope. The sensitivity of such displacement measurement is comparable with the wavelength of light. Dynamic mixed-mode stress intensity factors under shock loading were evaluated from the data obtained and subsequently compared with a numerical simulation by ANSYS software. As it was approved, the technique has shown sufficient sensitivity, good linearity, and measurement reliability. Due to its non-destructive nature and overall robustness, the arrangement is applicable even for structural component condition determination taking into consideration potentially unknown boundary conditions and the non-linear character of mechanical parameters.Keywords
Funding Information
- Agentúra Ministerstva Školstva, Vedy, Výskumu a Športu SR (SK-KEGA 025 STU-4/2019)
This publication has 14 references indexed in Scilit:
- Contact Response Analysis of Vertical Impact between Elastic Sphere and Elastic Half SpaceShock and Vibration, 2018
- Analysis of the Dynamic Stress Intensity Factor of an Impacted Freely Supported Bend Specimen Based on Modified Timoshenko's Beam TheoryProcedia Engineering, 2015
- Analysis of the dynamic responses for a pre-cracked three-point bend specimenInternational Journal of Fracture, 2004
- On the numerical evaluation of the anvil force for accurate dynamic stress intensity factor determinationEngineering Fracture Mechanics, 2003
- Dynamic analysis of one-point bend impact testEngineering Fracture Mechanics, 2000
- A method for dynamic fracture toughness determination using short beamsInternational Journal of Fracture, 2000
- On the influence of one-point-bend impact test parameters on dynamic stress intensity factor variationMaterials Science and Engineering: A, 1997
- Analytical and experimental determination of dynamic impact stress intensity factor for 40 Cr steelTheoretical and Applied Fracture Mechanics, 1997
- A simple formula for the dynamic stress intensity factor of an impacted freely-supported bend specimen.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 1988
- Energy losses due to elastic wave propagation during an elastic impactJournal of Physics D: Applied Physics, 1985