Realization of high-performance room temperature solid state Li-metal batteries using a LiF/PVDF-HFP composite membrane for protecting an LATP ceramic electrolyte
- 9 March 2023
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 11 (14) , 7605-7616
Abstract
The NASICON-type lithium aluminum titanium phosphate (LATP) solid-state electrolyte is considered as a promising candidate for next-generation lithium metal batteries with high energy density. However, the instability of LATP in the presence of Li metal and its poor contact with the electrodes hinder its practical application. Here, a novel protective-layer (PL) consisting of a PVDF-HFP polymer matrix and LiF ceramic particles was developed. The proposed layer provides a suitable interface between LATP and the electrodes, prevents the reduction of LATP by Li metal, and suppresses the growth of Li dendrites. The excellent performance of the PL|LATP|PL structure as a ceramic-polymer composite electrolyte (CPCE) was demonstrated by Li|CPCE|Li symmetric cell plating/stripping for 1000 hours at 0.5 mA cm−2 without a short circuit. In addition, the assembled LiFePO4|CPCE|Li full-cell was tested at two different C-rates of 0.2C and 1C. The cell cycled at 0.2C was durable and stable for about eight months and retained 86.4% of the initial capacity of 135.6 mA h g−1, while the other cell cycled at 1C had desirable cycling performance for 2000 cycles with little capacity degradation of about 12.5%. In this study, an efficient and robust composite electrolyte was proposed for the development of solid-state Li-metal batteries with high stability, long lifetime, and high power density.Keywords
This publication has 53 references indexed in Scilit:
- Co-polymerization and blending based PEO/PMMA/P(VDF-HFP) gel polymer electrolyte for rechargeable lithium metal batteriesJournal of Membrane Science, 2018
- Mechanisms and properties of ion-transport in inorganic solid electrolytesEnergy Storage Materials, 2018
- Facile synthesis of NASICON-type Li1.3Al0.3Ti1.7(PO4)3 solid electrolyte and its application for enhanced cyclic performance in lithium ion batteries through the introduction of an artificial Li3PO4 SEI layerRSC Advances, 2017
- Conformal Lithium Fluoride Protection Layer on Three-Dimensional Lithium by Nonhazardous Gaseous Reagent FreonNano Letters, 2017
- Durability of the Li1+xTi2–xAlx(PO4)3 Solid Electrolyte in Lithium–Sulfur BatteriesACS Energy Letters, 2016
- A microcontact impedance study on NASICON-type Li1+xAlxTi2−x(PO4)3(0 ≤ x ≤ 0.5) single crystalsJournal of Materials Chemistry A, 2015
- Dendrite-free Li deposition using trace-amounts of water as an electrolyte additiveNano Energy, 2015
- Gelled microporous polymer electrolyte with low liquid leakage for lithium-ion batteriesJournal of Membrane Science, 2014
- 3D ordered macroporous LaFeO3 as efficient electrocatalyst for Li–O2 batteries with enhanced rate capability and cyclic performanceEnergy & Environmental Science, 2013
- THE EFFECT OF PRECIPITATION PARAMETERS ON PREPARATION OF LITHIUM FLUORIDE (LIF) NANO-POWDERChemical Engineering Communications, 2007