Formation of integral skin polyurethane foams
Authors:
- 1 January 1999
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 39 (1) , 164-176
Abstract
Polyurethane integral skin foams comprise a low density foamed core surrounded by a high density skin of the same material, and are made in a single molding operation. Polyurethane integral skin foams find wide application as structural materials, and the mechanical properties of such foams are significantly affected by the foam structure, which in turn is determined by the foaming process. An experimental and theoretical study of the foam formation process is presented. Experimental results show that increase in the mold wall temperature results in an increase in the upper skin thickness, a decrease in the lower skin thickness, and a decrease in the density of both skins. The core density increases with increasing wall temperature. Increase in the blowing agent concentration produces a small increase in the skin thickness. Computations based on the model of Marciano et al. [Polym. Eng. Sci., 26, 717 (1986)] are presented using an efficient numerical technique. Predictions of the model for the skin thickness, core density and pressure and temperature variation with time are in reasonable agreement with experimental data. The model, however, predicts higher skin densities than the experimental measurements. A modification of the initial condition of the model to account for the air bubbles dispersed during mixing gives better agreement between theory and experiment.Keywords
This publication has 10 references indexed in Scilit:
- Flexural Properties of Mica Filled Polyurethane FoamsJournal of Cellular Plastics, 1997
- Optimization of the structure of integral skin foams for maximal flexural propertiesPolymer Engineering & Science, 1994
- Modeling of the dynamics of R‐11 blown polyurethane foam formationPolymer Engineering & Science, 1994
- Integral‐skin polyurethane foamsPolymer Engineering & Science, 1986
- Flexural properties of moldings of rigid polyurethane made by reaction injection moldingPolymer Engineering & Science, 1986
- Simulation of foaming process of polyurethane integral skin foamsPolymer Engineering & Science, 1985
- Some mechanical properties of rigid polyurethane structural foamPolymer Engineering & Science, 1983
- Handbook of Physical Properties of Liquids and Gases1975
- Integral-skin foam. A mechanism for skin formationJournal of Applied Polymer Science, 1972
- Polyurethane foam process development. A systems engineering approachJournal of Applied Polymer Science, 1972