Determining the Dynamic Increase Factor for Glued-Laminated Timber Beams
- 1 September 2018
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 144 (9)
Abstract
This paper presents the results from an experimental program that investigated the flexural behavior of glulam beams subjected to dynamic loading. A total of thirty-eight beams consisting of three different cross-sections were tested destructively under both static and dynamic loads. The analysis resulted in a dynamic increase factor (DIF) of 1.14 for strain-rates ranging between 0.14 and , however, the increase was only observed when the outer tension laminate did not include continuous finger-joints (single laminate width) or closely aligned finger-joints (multiple laminates width) in the high moment region causing a straight fracture across the width. No increase due to high strain-rate effects was found when a continuous failure across the width due to finger-joints (FJs) were present in the outer tension laminate, and thus if continuous laminates, uninterrupted by FJs cannot be guaranteed, a dynamic increase factor of unity is suggested for design. Since the beams exhibited little to no ductility, it is recommended that a linear-elastic resistance curve be used to generate the dynamic resistance curve. An equivalent single-degree-of-freedom (SDOF) model accounting for high strain-rate effects using the derived DIF, where appropriate, captured the displacement at failure, time to failure, and displaced shape with reasonable accuracy.
Keywords
This publication has 11 references indexed in Scilit:
- Experimental and Analytical Investigation of Cross-Laminated Timber Panels Subjected to Out-of-Plane Blast LoadsJournal of Structural Engineering, 2018
- Investigating the Behavior of Light-Frame Wood Stud Walls Subjected to Severe Blast LoadingJournal of Structural Engineering, 2016
- Investigation of Dynamic Increase Factors in Light-Frame Wood Stud Walls Subjected to Out-of-Plane Blast LoadingJournal of Structural Engineering, 2015
- Retrofit Options for Light-Frame Wood Stud Walls Subjected to Blast LoadingJournal of Structural Engineering, 2014
- Influence of high strain-rates on the dynamic flexural material properties of spruce–pine–fir wood studsCanadian Journal of Civil Engineering, 2014
- Load Duration Effects in Wood at High Strain RatesJournal of Materials in Civil Engineering, 2013
- The fracture of wood under impact loadingMaterials and Structures, 1986
- An explanation for the rate-of-loading and the duration-of-load effects in wood in terms of fracture mechanicsJournal of Materials Science, 1982
- DAMAGE TO CONVENTIONAL AND SPECIAL TYPES OF RESIDENCES EXPOSED TO NUCLEAR EFFECTS1961
- Stresses in impactJournal of the Franklin Institute, 1916