Optimized sensor placement for damage parameter estimation: Experimental results for a cracked plate
Authors:
- 12 March 2013
- journal article
- research article
- Published by SAGE Publications in Structural Health Monitoring
- Vol. 12 (3) , 197-206
Abstract
In this article, the optimum sensor and impact locations, for use in a damage identification experiment, are obtained using a hybrid genetic algorithm/steepest descent optimization method. Specifically, data from these optimum locations are used to identify the location, orientation, and size of a crack (termed the crack parameters) in a rectangular plate. The strain gage locations and orientations were selected in order (a) to maximize the difference between the model signal for a healthy plate and the model signal for a randomly damaged plate and (b) to minimize the cross-correlation among the signals measured by each of the gages. The latter requirement, in a sense, maximizes the uniqueness of the information measured from each sensor. The Bayesian model-based structural health monitoring identification technique, used to assess the crack parameters, was previously shown to be successful even for arbitrary sensor location/orientation and excitation location. It is shown here that thoughtful (optimized) sensor and excitation locations allow for improved estimates of the crack parameters. However, there is no substantial change in the width of the confidence intervals associated with these estimates.Keywords
This publication has 22 references indexed in Scilit:
- Crack identification in a freely vibrating plate using Bayesian parameter estimationMechanical Systems and Signal Processing, 2011
- Delamination identification of laminated composite plates using a continuum damage mechanics model and subset selection techniqueSmart Materials and Structures, 2010
- On Optimal Sensor Placement Criterion for Structural Health Monitoring with Representative Least Squares MethodKey Engineering Materials, 2009
- The optimal location of piezoelectric actuators and sensors for vibration control of platesSmart Materials and Structures, 2007
- Optimal placement and active vibration control for piezoelectric smart flexible cantilever plateJournal of Sound and Vibration, 2007
- Optimization of piezoelectric sensor location for delamination detection in composite laminatesEngineering Optimization, 2006
- The state of the art of sensor placement methods in structural health monitoring2006
- Detection of cracks in plates using piezo-actuated Lamb wavesSmart Materials and Structures, 2004
- Detection of structural damage through changes in frequency: a reviewEngineering Structures, 1997
- Sensor Placement and Structural Damage Identification from Minimal Sensor InformationAIAA Journal, 1997