Moisture-Induced Swelling of Coal
- 9 December 2009
- journal article
- research article
- Published by Taylor & Francis in International Journal of Coal Preparation and Utilization
- Vol. 29 (6) , 298-316
Abstract
The gas-induced swelling behavior of coal is important when considering CO2 sequestration into coal seams or enhanced coalbed methane applications, but coals may also swell in the presence of moisture, or shrink on drying. In this paper we examine the moisture-swelling properties of coals from Australia and elsewhere. Results on the moisture uptake and corresponding swelling measurements are presented for 15 coals of various ranks (sub-bituminous and bituminous) at 22°C and atmospheric pressure. Measurements were made by exposing sample blocks of coal (nominally 30 × 10 × 10 mm) to relative humidities ranging from 0% to 97%. A selection of coals was also fully saturated in water. Moisture uptake at 97% relative humidity (RH) ranged from about 2.5% to more than 16% db. Maximum linear strain associated with the moisture sorption (measured at 97% RH) varied from about 0.2% to 1.3%, with lower rank coals showing the most swelling. In all cases, swelling was greater in the direction perpendicular to the bedding plane. These results correspond to volumetric swelling of about 0.5% to around 5%. Although exhibiting significant expansion, all of the samples returned to their original dimensions upon drying. Volumetric moisture sorption and the amount of swelling induced were found to be strongly correlated by a single linear expression that held for all of the coals examined. It was further found that the volume of the water adsorbed was linearly related to the pore space within the coal, however, at 97% relative humidity, only about 60% of the available pore space is occupied by water. Exposure to liquid water allowed the pores to completely fill; although for the lowest rank coals, the volume of water absorbed appeared to be slightly more than the corresponding pore volume. Despite the additional water uptake, immersion in water did not produce further swelling beyond that induced at 97% relative humidity.Keywords
This publication has 16 references indexed in Scilit:
- Physical properties of selected block Argonne Premium bituminous coal related to CO2, CH4, and N2 adsorptionInternational Journal of Coal Geology, 2009
- Strain development in unconfined coals exposed to CO2, CH4 and Ar: Effect of moistureInternational Journal of Coal Geology, 2009
- Effect of coal properties on CO2 sorption capacity under supercritical conditionsInternational Journal of Greenhouse Gas Control, 2008
- Swelling of Australian coals in supercritical CO2International Journal of Coal Geology, 2008
- Multilayer sorption parameters: BET or GAB values?Colloids and Surfaces A: Physicochemical and Engineering Aspects, 2003
- Contribution of Mineral Matter to Water Associated with Bituminous CoalsEnergy & Fuels, 1998
- Structural Rearrangement of Strained CoalsEnergy & Fuels, 1997
- Moisture in coalFuel, 1989
- Densities, porosities and surface areas of coal macerals as measured by their interaction with gases, vapours and liquidsFuel, 1988
- Surface area and swellability of coalFuel, 1983