Stuart Day
Research Subjects
Stuart Day has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Robyn Fry
CSIRO Energy Technology , PO Box 330, Newcastle , NSW 2300 , Australia
3 shared publications- Richard Sakurovs
CSIRO Energy, 11 Julius Avenue, North Ryde, NSW 2113, Australia
2 shared publications Brendan Halliburton
CSIRO Energy Technology , PO Box 330, Newcastle , NSW 2300 , Australia
1 shared publicationDavid French
1 shared publicationDavid J. Williams
CSIRO Energy Technology
1 shared publicationDavid Williams
CSIRO Energy Technology , P.O. Box 330, Newcastle, NSW 2300, Australia
1 shared publication
Latest Publications
- 26 September 2012
- Published by Taylor & Francis in Greenhouse Gas Measurement and Management
- Vol. 2 (2-3) , 106-117
Fugitive greenhouse gas emissions in ventilation air from Australian underground coal mines
Seam gas released during coal mining is a substantial source of fugitive greenhouse gas emissions worldwide. Most of these emissions originate from underground mining; however, lack of robust global data means that the scale of emissions remains uncertain. Some coal-producing countries are attempting to improve the quality of emission estimates by using ventilation data to calculate emissions from individual mines. Legislation recently introduced in Australia now requires coal mine operators to estimate and report annual fugitive emissions. This article examines the methodology currently used at most Australian mines to meet these requirements. To assess the performance of this methodology, we compared the results of routine measurements of ventilation air flow rate and gas composition to those made with reference methods. The primary sources of uncertainty in the techniques are identified and their contributions to the uncertainty of the reported fugitive emission fluxes are estimated.
- 26 September 2012
- Published by Taylor & Francis in Greenhouse Gas Measurement and Management
- Vol. 2 (2-3) , 106-117
Fugitive greenhouse gas emissions in ventilation air from Australian underground coal mines
Seam gas released during coal mining is a substantial source of fugitive greenhouse gas emissions worldwide. Most of these emissions originate from underground mining; however, lack of robust global data means that the scale of emissions remains uncertain. Some coal-producing countries are attempting to improve the quality of emission estimates by using ventilation data to calculate emissions from individual mines. Legislation recently introduced in Australia now requires coal mine operators to estimate and report annual fugitive emissions. This article examines the methodology currently used at most Australian mines to meet these requirements. To assess the performance of this methodology, we compared the results of routine measurements of ventilation air flow rate and gas composition to those made with reference methods. The primary sources of uncertainty in the techniques are identified and their contributions to the uncertainty of the reported fugitive emission fluxes are estimated.
- 1 September 2012
- Published by Taylor & Francis in Greenhouse Gas Measurement and Management
- Vol. 2 (2-3) , 93-105
A comparison of three methods for the quantification of greenhouse gas emissions from spontaneous combustion in open-cut coal mines
Greenhouse gas emissions from spontaneous combustion in coal mines are currently excluded from national inventories by the United Nations Framework Convention on Climate Change because there are no robust methods available to quantify the emissions. This article reports on investigations of three approaches being pursued with the aim of developing methods which are sufficiently robust to enable these emissions to be included in inventories. The first method was based on the use of airborne thermal infrared photography coupled with chamber measurements of emissions from hot mine spoil pile surfaces. In the second method, crosswind traverses of the plume using an instrumented vehicle were used to estimate the emission fluxes. The third method was based on inverse atmospheric modelling using stationary CO2 monitors. All three methods showed considerable scatter in their estimates but also showed appreciable overlap. While the three methods used in this study have shown convergence, there is still considerable uncertainty associated with any single approach.
- 1 September 2012
- Published by Taylor & Francis in Greenhouse Gas Measurement and Management
- Vol. 2 (2-3) , 93-105
A comparison of three methods for the quantification of greenhouse gas emissions from spontaneous combustion in open-cut coal mines
Greenhouse gas emissions from spontaneous combustion in coal mines are currently excluded from national inventories by the United Nations Framework Convention on Climate Change because there are no robust methods available to quantify the emissions. This article reports on investigations of three approaches being pursued with the aim of developing methods which are sufficiently robust to enable these emissions to be included in inventories. The first method was based on the use of airborne thermal infrared photography coupled with chamber measurements of emissions from hot mine spoil pile surfaces. In the second method, crosswind traverses of the plume using an instrumented vehicle were used to estimate the emission fluxes. The third method was based on inverse atmospheric modelling using stationary CO2 monitors. All three methods showed considerable scatter in their estimates but also showed appreciable overlap. While the three methods used in this study have shown convergence, there is still considerable uncertainty associated with any single approach.
- 1 June 2011
- Published by Elsevier in International Journal of Coal Geology
- Vol. 86 (4) , 367-371
Effect of impurity gases in carbon dioxide on sorption behavior and mineral matter in an Australian bituminous coal
- 1 June 2011
- Published by Elsevier in International Journal of Coal Geology
- Vol. 86 (4) , 367-371
Effect of impurity gases in carbon dioxide on sorption behavior and mineral matter in an Australian bituminous coal
- 9 December 2009
- Published by Taylor & Francis in International Journal of Coal Preparation and Utilization
- Vol. 29 (6) , 298-316
Moisture-Induced Swelling of Coal
The gas-induced swelling behavior of coal is important when considering CO2 sequestration into coal seams or enhanced coalbed methane applications, but coals may also swell in the presence of moisture, or shrink on drying. In this paper we examine the moisture-swelling properties of coals from Australia and elsewhere. Results on the moisture uptake and corresponding swelling measurements are presented for 15 coals of various ranks (sub-bituminous and bituminous) at 22°C and atmospheric pressure. Measurements were made by exposing sample blocks of coal (nominally 30 × 10 × 10 mm) to relative humidities ranging from 0% to 97%. A selection of coals was also fully saturated in water. Moisture uptake at 97% relative humidity (RH) ranged from about 2.5% to more than 16% db. Maximum linear strain associated with the moisture sorption (measured at 97% RH) varied from about 0.2% to 1.3%, with lower rank coals showing the most swelling. In all cases, swelling was greater in the direction perpendicular to the bedding plane. These results correspond to volumetric swelling of about 0.5% to around 5%. Although exhibiting significant expansion, all of the samples returned to their original dimensions upon drying. Volumetric moisture sorption and the amount of swelling induced were found to be strongly correlated by a single linear expression that held for all of the coals examined. It was further found that the volume of the water adsorbed was linearly related to the pore space within the coal, however, at 97% relative humidity, only about 60% of the available pore space is occupied by water. Exposure to liquid water allowed the pores to completely fill; although for the lowest rank coals, the volume of water absorbed appeared to be slightly more than the corresponding pore volume. Despite the additional water uptake, immersion in water did not produce further swelling beyond that induced at 97% relative humidity.
- 9 December 2009
- Published by Taylor & Francis in International Journal of Coal Preparation and Utilization
- Vol. 29 (6) , 298-316
Moisture-Induced Swelling of Coal
The gas-induced swelling behavior of coal is important when considering CO2 sequestration into coal seams or enhanced coalbed methane applications, but coals may also swell in the presence of moisture, or shrink on drying. In this paper we examine the moisture-swelling properties of coals from Australia and elsewhere. Results on the moisture uptake and corresponding swelling measurements are presented for 15 coals of various ranks (sub-bituminous and bituminous) at 22°C and atmospheric pressure. Measurements were made by exposing sample blocks of coal (nominally 30 × 10 × 10 mm) to relative humidities ranging from 0% to 97%. A selection of coals was also fully saturated in water. Moisture uptake at 97% relative humidity (RH) ranged from about 2.5% to more than 16% db. Maximum linear strain associated with the moisture sorption (measured at 97% RH) varied from about 0.2% to 1.3%, with lower rank coals showing the most swelling. In all cases, swelling was greater in the direction perpendicular to the bedding plane. These results correspond to volumetric swelling of about 0.5% to around 5%. Although exhibiting significant expansion, all of the samples returned to their original dimensions upon drying. Volumetric moisture sorption and the amount of swelling induced were found to be strongly correlated by a single linear expression that held for all of the coals examined. It was further found that the volume of the water adsorbed was linearly related to the pore space within the coal, however, at 97% relative humidity, only about 60% of the available pore space is occupied by water. Exposure to liquid water allowed the pores to completely fill; although for the lowest rank coals, the volume of water absorbed appeared to be slightly more than the corresponding pore volume. Despite the additional water uptake, immersion in water did not produce further swelling beyond that induced at 97% relative humidity.
- 27 June 2009
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 166 (1-4) , 529-541
Greenhouse gas emissions from Australian open-cut coal mines: contribution from spontaneous combustion and low-temperature oxidation
Spontaneous combustion and low-temperature oxidation of waste coal and other carbonaceous material at open-cut coal mines are potentially significant sources of greenhouse gas emissions. However, the magnitude of these emissions is largely unknown. In this study, emissions from spontaneous combustion and low-temperature oxidation were estimated for six Australian open-cut coal mines with annual coal production ranging from 1.7 to more than 16 Mt. Greenhouse emissions from all other sources at these mines were also estimated and compared to those from spontaneous combustion and low-temperature oxidation. In all cases, fugitive emission of methane was the largest source of greenhouse gas; however, in some mines, spontaneous combustion accounted for almost a third of all emissions. For one mine, it was estimated that emissions from spontaneous combustion were around 250,000 t CO2-e per annum. The contribution from low-temperature oxidation was generally less than about 1% of the total for all six mines. Estimating areas of spoil affected by spontaneous combustion by ground-based surveys was prone to under-report the area. Airborne infrared imaging appears to be a more reliable method.
- 27 June 2009
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 166 (1-4) , 529-541
Greenhouse gas emissions from Australian open-cut coal mines: contribution from spontaneous combustion and low-temperature oxidation
Spontaneous combustion and low-temperature oxidation of waste coal and other carbonaceous material at open-cut coal mines are potentially significant sources of greenhouse gas emissions. However, the magnitude of these emissions is largely unknown. In this study, emissions from spontaneous combustion and low-temperature oxidation were estimated for six Australian open-cut coal mines with annual coal production ranging from 1.7 to more than 16 Mt. Greenhouse emissions from all other sources at these mines were also estimated and compared to those from spontaneous combustion and low-temperature oxidation. In all cases, fugitive emission of methane was the largest source of greenhouse gas; however, in some mines, spontaneous combustion accounted for almost a third of all emissions. For one mine, it was estimated that emissions from spontaneous combustion were around 250,000 t CO2-e per annum. The contribution from low-temperature oxidation was generally less than about 1% of the total for all six mines. Estimating areas of spoil affected by spontaneous combustion by ground-based surveys was prone to under-report the area. Airborne infrared imaging appears to be a more reliable method.