Eliminating artificial surfactant-mass drift in nonlinear weighted-residual models of soluble-surfactant-laden falling films
- 1 September 2026
- journal article
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (9)
Abstract
A soluble surfactant may adsorb at a free surface and desorb into the liquid bulk, but in a closed periodic falling film the total amount of surfactant must remain constant. We use this invariant as a test of nonlinear weighted-residual models for soluble-surfactant-laden films. The models of Pascal et al. [“Stability of inclined flow of a liquid film with soluble surfactants and variable mass density,” Phys. Rev. Fluids 4, 054004 (2019)] and D'Alessio et al. [“Marangoni instabilities associated with heated surfactant-laden falling films,” J. Fluid Mech. 887, A20 (2020)] correctly include the bulk-surface exchange mechanism, but their nonlinear surface closure contains a coefficient that prevents exact conservation of the reduced total surfactant mass. The problematic contribution is proportional to (5/4)ΓΓxhx: it leaves a residual ΓΓxhx that is not a conservative streamwise flux and therefore behaves as an artificial source during nonlinear evolution. We return to Stone's [“A simple derivation of the time-dependent convective-diffusion equation for surfactant transport along a deforming interface,” Phys. Fluids A 2, 111–112 (1990)] material-surface balance, add the Langmuir adsorption–desorption flux, and then take the thin-film long-wave limit used in the weighted-residual reduction. The normal-motion/curvature area-dilation term in Stone's [“A simple derivation of the time-dependent convective-diffusion equation for surfactant transport along a deforming interface,” Phys. Fluids A 2, 111–112 (1990)] equation is shown explicitly to enter two orders higher in the nondimensional surface balance than the retained Marangoni correction. With the same velocity and concentration ansatz used in the earlier weighted-residual framework, the conservative reduction gives the coefficient 1/4. The nonlinear surface term then becomes (1/4)∂x(hΓΓx), the corresponding bulk Marangoni term is also a periodic flux, and the adsorption–desorption terms cancel between the bulk and surface equations. Nonlinear simulations for a comparable parameter set based on the earlier published studies confirm that the corrected model conserves the total reduced surfactant mass to numerical accuracy and removes the secular growth in the surface concentration range, while leaving the linear stability problem unchanged.Keywords
Funding Information
- International Institute of Information Technology Bangalore (17)
This publication has 22 references indexed in Scilit:
- Stability of liquid film flow laden with the soluble surfactant sodium dodecyl sulphate: predictions versus experimental dataJournal of Fluid Mechanics, 2020
- Surfactant dynamics: hidden variables controlling fluid flowsJournal of Fluid Mechanics, 2020
- Marangoni instabilities associated with heated surfactant-laden falling filmsJournal of Fluid Mechanics, 2020
- Measurements of the stabilisation of liquid film flow by the soluble surfactant sodium dodecyl sulfate (SDS)International Journal of Multiphase Flow, 2016
- The role of surfactants on the mechanism of the long-wave instability in liquid film flowsJournal of Fluid Mechanics, 2014
- The primary instability of falling films in the presence of soluble surfactantsJournal of Fluid Mechanics, 2013
- Effect of surfactant on the stability of film flow down an inclined planeJournal of Fluid Mechanics, 2004
- Improved modeling of flows down inclined planesThe European Physical Journal B, 2000
- Modeling film flows down inclined planesThe European Physical Journal B, 1998
- EFFECTS OF SURFACE CONTAMINATION ON WAVE FORMATION IN FALLING LIQUID FILMS1965