The influence of grinding conditions on surface roughness parameters of 20MnCr5 steel vacuum-carburised by single-piece flow method
Authors:
- M SikoraMSM Sikora
- P ZgórniakPZP Zgórniak
- E Wołowiec-KoreckaEWE Wołowiec-Korecka
Open Access
- 1 February 2020
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 743 (1)
Abstract
The purpose of the experimental tests described in the article was to determine the effect of selected abrasive machining conditions on the value of surface roughness of 20MnCr5 steel samples. The samples were subjected to vacuum carburising (LPC) using the ‘single-piece flow’ method and high-pressure gas quenching (HPGQ) in a 4D Quenching chamber to obtain an effective case depth (ECD) of 0.4 mm. Next, the samples were ground with a Norton Vortex corundum grinding wheel. Cooling and lubricating fluid was delivered to the grinding zone using the flooding method (WET) and with the minimum quantity lubrication method (MQL). The samples were ground in one pass of the grinding wheel using two grinding depths – ae = 0.01 mm and ae = 0.02 mm. For each grinding test, surface roughness measurements were made using a stationary laboratory profilometer T8000 from Hommel Werke. These measurements enabled the determination of the 2D and 3D roughness parameters. Analysis of the measurement results showed that for the adopted test conditions, the use of the MQL method resulted in a decrease in surface roughness compared to the surface ground using the WET method. This property applies to both tested grinding depths.Keywords
This publication has 22 references indexed in Scilit:
- Influence of the condition of the surface layer of a hob cutter sharpened using the MQL-CCA hybrid method of coolant provision on its operational wearThe International Journal of Advanced Manufacturing Technology, 2018
- Influence of application of hybrid MQL-CCA method of applying coolant during hob cutter sharpening on cutting blade surface conditionJournal of Cleaner Production, 2018
- THE INFLUENCE OF GRINDING CONDITIONS ON THE DISTRIBUTION OF RESIDUAL STRESS IN THE SURFACE LAYER OF 17crni6-6 STEEL AFTER CARBURIZINGAdvances in Science and Technology Research Journal, 2017
- Energy Efficient Process Chain: The Impact of Cutting Fluid StrategiesProcedia CIRP, 2015
- A Review on Minimum Quantity Lubrication for Machining ProcessesMaterials and Manufacturing Processes, 2014
- Environmental friendly cutting fluids and cooling techniques in machining: a reviewJournal of Cleaner Production, 2014
- Minimum quantity lubrication in grinding: effects of abrasive and coolant–lubricant typesJournal of Cleaner Production, 2011
- Transitioning to sustainable production – part II: evaluation of sustainable machining technologiesJournal of Cleaner Production, 2010
- Macro-level environmental comparison of near-dry machining and flood machiningJournal of Cleaner Production, 2010
- Dry Machining and Minimum Quantity LubricationCIRP Annals, 2004