Investigations on spark pre-chamber ignition and subsequent turbulent jet main chamber ignition in a novel optically accessible test rig
- 25 May 2021
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 23 (9) , 1543-1555
Abstract
Turbulent jet ignition (TJI) is a promising strategy to ignite diluted air-fuel mixtures; this is usually generated by igniting a fraction of the mixture inside a small pre-chamber. Nevertheless, the processes that take place inside the pre-chamber, as well as the injection of the turbulent jet into the main chamber and its subsequent re-ignition are not fully understood. The current work presents an experimental investigation that studies the effects of the nozzle size, turbulence level, and air-fuel mixture on the pre-chamber ignition and main chamber re-ignition and combustion. To accomplish this, a series of experiments have been carried out under different boundary conditions. To understand the phenomena taking place in the pre- and main chamber, two different approaches were taken: On one hand, (1) pressure-based diagnostics were applied by fitting a pressure sensor in each of the chambers. This was done to trace the pressure evolution during the whole combustion event and to calculate the heat-release. On the other hand, (2) optical diagnostics were setup on both combustion chambers, using dual schlieren setups synchronized at the same frame rate. The optically accessible test rig and the combination of schlieren in the pre-chamber (PC) & main-chamber (MC) allows to visualize the ignition, flame propagation, quenching mechanisms and re-ignition under a wide range of boundary conditions. This combined with the pressure traces and heat-release give a full understanding of the ignition and combustion processes. Higher turbulence levels and equivalence ratios increase the propagation of the flame front and the peak pressure in the pre-chamber. The resulting higher nozzle-exit velocities lead, on one hand, to faster mixing and therefore to a larger portion of main chamber fuel within the jet, which decrease the main chamber combustion duration. On the other hand, to high quenching and longer re-ignition times, which show the adverse effect.Keywords
This publication has 33 references indexed in Scilit:
- Study of prechamber combustion characteristics in a rapid compression and expansion machineApplied Thermal Engineering, 2017
- Investigation of natural gas energy fraction and injection timing on the performance and emissions of a dual-fuel engine with pre-combustion chamber under low engine loadApplied Energy, 2017
- On ignition mechanisms of premixed CH 4 /air and H 2 /air using a hot turbulent jet generated by pre-chamber combustionApplied Thermal Engineering, 2016
- A study of the influence of orifice diameter on a turbulent jet ignition system through combustion visualization and performance characterization in a rapid compression machineApplied Thermal Engineering, 2015
- Prechamber NOx formation in low BMEP 2-stroke cycle natural gas enginesApplied Thermal Engineering, 2009
- Low-emission combustion of a pre-chamber-type compression ignition natural gas engineInternational Journal of Engine Research, 2007
- A thermal formulation for single-wall quenching of transient laminar flamesCombustion and Flame, 2007
- Detailed investigation of ignition by hot gas jetsProceedings of the Combustion Institute, 2007
- Comparison between direct and indirect (prechamber) spark ignition in the case of a cogeneration natural gas engine,Applied Thermal Engineering, 2002
- Comparison between direct and indirect (prechamber) spark ignition in the case of a cogeneration natural gas engine, part I: engine geometrical parametersApplied Thermal Engineering, 2002