Formation and mechanical properties of Cu–Hf–Al bulk glassy alloys with a large supercooled liquid region of over 90 K
Authors:
- 1 June 2003
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 18 (6) , 1435-1440
Abstract
New Cu-based bulk glassy alloys with large supercooled liquid regions and high mechanical strength were formed in Cu–Hf–Al ternary systems. The large supercooled liquid region exceeding 70 K was obtained in the composition range of 40 at.% Hf at 2.5% Al, 37.5–50% Hf at 5% Al, and 45% Hf at 7.5% Al. The largest supercooled liquid region ΔTx(= Tx – Tg) was 91 K for Cu50Hf45Al5 alloy, and the highest reduced glass-transition temperature was 0.63 for Cu50Hf42.5Al7.5 and Cu52.5Hf40Al7.5 alloys. The alloys with large ΔTx values above 50 K were formed into bulk glassy rods with diameters up to 3 mm by copper mold casting, and the glassy alloy rods exhibited high compressive fracture strength of 2260 to 2370 MPa and Young's modulus of 121 to 128 GPa combined with elastic elongation of 1.9% to 2.0% and plastic elongation of 0.2% to 0.6%. No bulk glassy alloys were formed in the Cu–Hf binary system by copper mold casting, and, hence, the addition of 2.5% to 7.5% Al to Cu–Hf alloys was very effective for increasing glass-forming ability as well as the stabilization of supercooled liquid. The effectiveness can be interpreted on the basis of the concept of the formation of a unique glassy structure in special multicomponent alloys with the three component rules.Keywords
This publication has 25 references indexed in Scilit:
- New Bulk Glassy Ni-Based Alloys with High Strength of 3000 MPaMATERIALS TRANSACTIONS, 2002
- Formation and mechanical properties of Cu–Hf–Ti bulk glassy alloys [Article Retracted]Journal of Materials Research, 2001
- High-Strength Cu-Based Bulk Glassy Alloys in Cu-Zr-Ti-Be SystemMATERIALS TRANSACTIONS, 2001
- Bulk amorphous alloys with high mechanical strength and good soft magnetic properties in Fe–TM–B (TM=IV–VIII group transition metal) systemApplied Physics Letters, 1997
- Effect of Additional Elements on Glass Transition Behavior and Glass Formation Tendency of Zr–Al–Cu–Ni AlloysMaterials Transactions, JIM, 1995
- Fe-Based Ferromagnetic Glassy Alloys with Wide Supercooled Liquid RegionMaterials Transactions, JIM, 1995
- A highly processable metallic glass: Zr41.2Ti13.8Cu12.5Ni10.0Be22.5Applied Physics Letters, 1993
- Production of Amorphous Cylinder and Sheet of La55Al25Ni20 Alloy by a Metallic Mold Casting MethodMaterials Transactions, JIM, 1990
- Al–La–Ni Amorphous Alloys with a Wide Supercooled Liquid RegionMaterials Transactions, JIM, 1989
- New Amorphous Mg-Ce-Ni Alloys with High Strength and Good DuctilityJapanese Journal of Applied Physics, 1988