Experimental Wear Behavior Analysis of Coated Spindle Hook Teeth under Real Harvesting Work Conditions
Open Access
Abstract
This study aimed to investigate the wear failure changes of spindle hook teeth and the reasons for such failure during field work. Spindle samples were obtained from a fixed position of the spindle bar under different field picking area conditions and combined with the spatial distribution characteristics of cotton bolls in Xinjiang. After cutting a spindle sample, a scanning electron microscope and an energy spectrum analyzer were used to characterize the micromorphology and element composition of the hook tooth surface and cross section under different working area conditions. The wear parameters of the hook teeth were then extracted. The results showed that the thickness of the coating on the surface of the hook tooth used in this study was between 66.1 µm and 74.4 µm. The major chemical element was chromium, with a small amount of nickel. During the field picking process, failure of the coating on the surface of the hook teeth initially appeared on the tooth tip and tooth edge, and then spread to the entire hook tooth surface. The wear failure of the hook teeth resulted from abrasive wear, oxidative wear, and fatigue peeling. As the picking area increased, the wear area of the hook teeth increased exponentially, while the wear width increased linearly. When the field picking area reached 533.33 ha, the maximum change rate of the wear area was 2.33 × 103 µm2/ha, and the wear width was 1.84 µm/ha. During field work, the thickness of the coating decreased from the cutting surface to the tooth edge, and the wear rate gradually increased. The wear rate at Position 1 was the slowest, at 0.01 µm/ha, and the wear rate at Position 5 was the fastest, at 0.25 µm/ha.Keywords
Funding Information
- the Innovation and Development Project of the Shihezi University (CXFZ202015)
- Fundamental Research Funds for the Central Universities (KYXJ202002)
- the Corps Major Scientific and Technological Projects (2018AA008)
- the Corps Key Field Innovative Team Building Project (2019CB006)
This publication has 27 references indexed in Scilit:
- Impact of Climate Warming on Cotton Growth and Yields in China and Pakistan: A Regional PerspectiveAgriculture, 2021
- Competition for Light Interception in Cotton Populations of Different DensitiesAgronomy, 2021
- Wear Behavior of Ni-Based Composite Coatings with Dual Nano-SiC: Graphite Powder MixCoatings, 2020
- Wear Behavior of Spindles of Cotton Picker in Field WorkJournal of Tribology, 2020
- Experimental Investigation on Friction and Wear Behavior of the Vertical Spindle and V-belt of a Cotton PickerMaterials, 2019
- Variability of fiber friction among cotton varieties: Influence of salient fiber physical metricsTribology International, 2018
- Spindle Diameter Effects for Cotton PickersApplied Engineering in Agriculture, 2017
- Friction and wear behavior of electroless nick coating used for spindle of cotton pickerIndustrial Lubrication and Tribology, 2016
- Hard chromium coating effects on tribological performances for nonlubricated and lubricated spindle of cotton pickerProceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, 2015
- Tribology and Micromechanics of Chromium Nitride Based Multilayer Coatings on Soft and Hard SubstratesCoatings, 2014