The Effect of a Taper Angle on Micro-Compression Testing of Mo-B-C Coatings
Open Access
Abstract
This research was devoted to studying the influence of the taper angle on the micro-compression of micro-pillars fabricated from near-amorphous and nanocrystalline Mo-B-C coatings. A series of micro-pillars with a taper angle between 4–14° was fabricated by focused ion beam technique. The deformation mechanism was found to be dependent on the taper and, also, on the crystallinity of the coating. In order to obtain correct values of yield strength and Young’s modulus, three empirical models of stress correction were experimentally tested, and the results were compared with nanoindentation measurements. It was shown that the average stress correction model provided comparable results with nanoindentation for the yield strength for taper angles up to ~10°. On the other hand, the average radius or area model gave the most precise results for Young’s modulus if the taper angle was <10°.Keywords
Funding Information
- Ministerstvo Školství, Mládeže a Tělovýchovy (LM2018097)
- Grantová Agentura České Republiky (Project 19-03899S)
This publication has 28 references indexed in Scilit:
- Evaluation of Micro-Pillar Compression Tests for Accurate Determination of Elastic-Plastic Constitutive RelationsJournal of Applied Mechanics, 2012
- Fracture modes in micropillar compression of brittle crystalsJournal of Materials Research, 2011
- Mechanical properties of Cu6Sn5 intermetallic by micropillar compression testingScripta Materialia, 2010
- A proposal for an unusually stiff and moderately ductile hard coating material: Mo2BCJournal of Physics D: Applied Physics, 2009
- Brittle‐to‐Ductile Transition in Uniaxial Compression of Silicon Pillars at Room TemperatureAdvanced Functional Materials, 2009
- Nanoscale gold pillars strengthened through dislocation starvationPhysical Review B, 2006
- The design of accurate micro-compression experimentsScripta Materialia, 2006
- Size dependence of mechanical properties of gold at the micron scale in the absence of strain gradientsActa Materialia, 2005
- Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodologyJournal of Materials Research, 2004
- The relation between load and penetration in the axisymmetric boussinesq problem for a punch of arbitrary profileInternational Journal of Engineering Science, 1965