Tribological Behaviors of Oxynitride Coating on TC4 Alloy Prepared by Double Glow Technology
Authors:
Open Access
- 24 September 2024
- journal article
- research article
- Published by Polish Academy of Sciences Chancellery in Archives of Metallurgy and Materials
- Vol. 69 (3) , 851-858
Abstract
The oxynitride coating was fabricated on the surface of Ti6Al4V alloy via double glow plasma alloy technology to enhance the wear resistance. The protective coating is dense and homogeneous and has a multilayer structure (outermost oxygen-rich layer, middle nitrogen-rich layer, innermost nitrogen diffusion layer). The acoustic emission curve suggests that the critical load is 53.1 N, the bonding strength between oxynitride coating and substrate is adequate to the application due to the diffusion layer. The oxynitride coating has a maximum hardness about 1020 HV, which is significant harder than Ti6Al4V alloy (370 HV). Tribological behaviors of oxynitride coating were investigated at three loads. The results indicated that the friction coefficient of oxynitride coating is lower than that of substrate at the same conditions. The wear mechanism of oxynitride coating is mainly fatigue wear, which converts to adhesive wear and fatigue wear with increasing load. The protective layer can decrease the actual contact areas obviously during the wear tests, which attributed to the higher hardness and stability of oxynitride layer.Keywords
This publication has 23 references indexed in Scilit:
- Cytocompatibility Evaluation of Ti-6Al-4V Alloy After Gas OxynitridingJournal of Materials Engineering and Performance, 2020
- Additive manufacturing of Ti6Al4V alloy: A reviewMaterials & Design, 2019
- A review on the fatigue behavior of Ti-6Al-4V fabricated by electron beam melting additive manufacturingInternational Journal of Fatigue, 2019
- Electrochemical Behavior of Ti–6Al–4V Alloy in Ringer’s Solution After OxynitridingMaterials Science, 2019
- Preparation and characterization of Cr/CrC multilayer on γ-TiAl alloy by the double glow plasma surface alloying technologyMaterials Letters, 2018
- Oxidation behavior of NiCoCrAlY coatings deposited by double-Glow plasma alloyingApplied Surface Science, 2018
- High-temperature tribological behaviors of a Cr-Si co-alloyed layer on TA15 alloyChinese Journal of Aeronautics, 2017
- Preparation and high-temperature oxidation behavior of plasma Cr–Ni alloying on Ti6Al4V alloy based on double glow plasma surface metallurgy technologyApplied Surface Science, 2016
- Comparative study of plasma oxynitriding and plasma nitriding for AISI 4140 steelJournal of Alloys and Compounds, 2016
- Effects of post-weld heat treatment on microstructure and mechanical properties of linear friction welded Ti2AlNb alloyMaterials & Design, 2016