Characterizing ZnMgO/Sb2Se3 Interface for Solar Cell Applications
- 26 November 2024
- journal article
- research article
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 19 (2)
Abstract
This study investigates the band alignment of the Zn0.8Mg0.2O/Sb2Se3 interface structure to improve solar cell performance. Sb2Se3 is a promising absorber material. However, Sb2Se3 solar cells exhibit a lower conversion efficiency than CuInGaSe2 and CdTe solar cells. The lower efficiency of Sb2Se3 solar cells is attributed to the severe open‐circuit voltage loss caused by the band structure at the buffer/Sb2Se3 interface. Sb2Se3 solar cells typically employ CdS as the buffer layer, and the CdS/Sb2Se3 interface exhibits a cliff structure, which results in interfacial recombination. By contrast, a ZnMgO buffer layer can form a spike structure with Sb2Se3 at their interface, which reduces recombination and, as a result, enhances conversion efficiency. Therefore, this study employs the ZnMgO buffer layer and analyzes their material properties with various Mg contents and band structure at buffer/absorber layer interface. A ZnMgO buffer layer is sputter‐deposited on Sb2Se3. The optical bandgap of ZnMgO is 3.3–3.72 eV, corresponding to an Mg content of 0–0.35 at%. The carrier concentration indicates an appropriate doping level ranging from 1014 to 1016 cm−3. The Zn0.8Mg0.2O/Sb2Se3 interface is characterized via interface‐induced band bending. The Zn0.8Mg0.2O/Sb2Se3 interface exhibits a spike structure with a positive delta conduction band offset of +0.193 eV.Keywords
This publication has 31 references indexed in Scilit:
- Simultaneous Band Alignment Modulation and Carrier Dynamics Optimization Enable Highest Efficiency in Cd‐Free Sb2Se3 Solar CellsAdvanced Functional Materials, 2024
- Sb2Se3 Thin‐Film Solar Cells Exceeding 10% Power Conversion Efficiency Enabled by Injection Vapor Deposition TechnologyAdvanced Materials, 2022
- Distinctive Deep‐Level Defects in Non‐Stoichiometric Sb2Se3 Photovoltaic MaterialsAdvanced Science, 2022
- Importance of Fine Control of Se Flux for Improving Performances of Sb2Se3 Solar Cells Prepared by Vapor Transport DepositionSolar RRL, 2021
- Boosting VOC of antimony chalcogenide solar cells: A review on interfaces and defectsNano Select, 2021
- Characterization of Surface and Heterointerface of Cu2ZnSn1–xGexSe4 for Solar Cell ApplicationsPhysica Status Solidi (RRL) – Rapid Research Letters, 2020
- Improved efficiency by insertion of Zn1−xMgxO through sol-gel method in ZnO/Sb2Se3 solar cellSolar Energy, 2018
- Sb2Se3 Thin‐Film Photovoltaics Using Aqueous Solution Sprayed SnO2 as the Buffer LayerAdvanced Electronic Materials, 2017
- CZTS-based materials and interfaces and their effects on the performance of thin film solar cellsPhysica Status Solidi (RRL) – Rapid Research Letters, 2014
- Enhanced Electron Mobility Due to Dopant‐Defect Pairing in Conductive ZnMgOAdvanced Functional Materials, 2014