Mechanical and fracture behavior of B4C reinforced Al composites produced by hot pressing
- 14 January 2016
- journal article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 58 (2) , 133-139
Abstract
In this study, the effects of particle addition on the microstructure, mechanical properties and fracture behaviors of Al/B4C particle reinforced composite produced by hot pressing method were investigated. After the production of 5, 10 and 15 wt.-% of B4C reinforced composites, T6 heat treatment was applied. It was specified that a strong interface bond occurred between the matrix and particles, and during the fracturing of composites, this effect increased the particle fracture. It was observed that particles were fractured parallel to the fracture surface and to each other fracture surface of MMCp. In general, cavity of particle separated from the matrix was not seen. In the production of MMCp, it was also observed that hot pressing provided a density higher than 99 %. After the heat treatment the maximum hardness value of 173 HB was reached with 15 wt.-% B4C reinforced sample. The transverse rupture strength (TRS) decreased with the increase of reinforcement ratio. The highest TRS was 510 MPa with the 5 wt.-% reinforced material, whereas the lowest value was obtained to be 387 MPa with the 15 wt.-% B4C reinforced material.Keywords
This publication has 28 references indexed in Scilit:
- In situ TiBw/Ti–6Al–4V composites with novel reinforcement architecture fabricated by reaction hot pressingScripta Materialia, 2009
- Application of traditional investment casting process to aluminium matrix compositesComposites Part A: Applied Science and Manufacturing, 2008
- Tensile behavior and dynamic failure of aluminum 6092/B4C compositesMaterials Science and Engineering: A, 2006
- Influence of Synthesis Temperature on the Defect Structure of Boron Carbide: Experimental and Modeling StudiesJournal of the American Ceramic Society, 2005
- Synthesis of Dense, High‐Defect‐Concentration B4C through Mechanical Activation and Field‐Assisted CombustionJournal of the American Ceramic Society, 2004
- Al–SiC ELECTRONIC PACKAGES WITH CONTROLLED THERMAL EXPANSION COEFFICIENT BY A NEW METHOD OF PRESSURELESS INFILTRATIONMaterials and Manufacturing Processes, 2002
- In situ processing of TiB2/TiC ceramic composites by thermal explosion under pressure: experimental study and modelingMaterials Science and Engineering: A, 2001
- Commercial processing of metal matrix compositesMaterials Science and Engineering: A, 1998
- Densification, microstructure and mechanical properties of TiB2-B4C based compositesInternational Journal of Refractory Metals and Hard Materials, 1996
- Aspects of fracture in particulate reinforced metal matrix compositesActa Metallurgica et Materialia, 1991