Experimental and simulation approach of cooling system in 3-phase inverter using extended surface
Open Access
- 1 December 2022
- journal article
- research article
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 13 (4) , 2313-2323
Abstract
Overheating is a failure mode that significantly affects the reliability of electronic devices. All electronic devices, including a 3-phase inverter driving a traction motor, produce heat dissipation. Heat dissipation needs to be controlled with cooling to prevent overheating. Overheating can be avoided by increasing cooling or reducing heat dissipation. Heat dissipation in the 3-phase inverter is caused by the internal resistance of the metal–oxide–semiconductor field-effect transistor (MOSFET), switching loss, and other factors. Cooling for the 3-phase inverter can use water coolant or air coolant. The cooling system is based on the amount of heat dissipation produced. Cooling of a 3-phase inverter can use air coolant with the addition of an extended surface area in the heat sink. The heat sink uses aluminum material, often called pin fin. There are kinds of aluminum available in the market. We calculated heat generation based on the MOSFET's internal resistance, switching loss, and other factors. We validated the simulation results experimentally using a thermal camera. Thus, we could find an optimal number, dimensions, and aluminum type of fin for the cooling system in the 3-phase inverter.Keywords
This publication has 18 references indexed in Scilit:
- An Electronic Control Unit for Thermoelectric Cooling2019
- Thermal modeling of the cooling of a power MOSFET by heat pipes2017
- Heat Management in Power Converters: From State of the Art to Future Ultrahigh Efficiency SystemsIEEE Transactions on Power Electronics, 2015
- Intelligent cooling system for three level inverter2015
- Design of Cooling Systems Using Computational Fluid Dynamics and Analytical Thermal ModelsIEEE Transactions on Industrial Electronics, 2013
- Fuzzy and adaptive fuzzy PI controller based Vector control for permanent magnet synchronous motor2013
- PM Synchronous Motor Speed Control Using Hybrid Fuzzy-PI With Novel Switching FunctionsIEEE Transactions on Magnetics, 2009
- Performances of fuzzy-logic-based vector control for permanent magnet synchronous motor used in elevator drive system2005
- Thermal modeling for power MOSFETs in DC/DC applications2004
- Numerical simulation of cool MOS transistor2002