3D Investigation of Fatigue Crack Morphology and Crack Growth of Iron-Based Materials via Synchrotron X-Ray CT
Authors:
- 1 November 2015
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 833, 154-157
Abstract
The present paper addresses a 3D investigation of a complicated fatigue crack profile and crack growth behavior in cast Hadfield high manganese steel by in-situ X-ray computed tomography (CT) experiments. In-situ loading experiments were performed on fatigue pre-cracked samples at the X-ray beamline BL13W1 of Shanghai synchrotron radiation facility in China, and high-resolution phase contrast imaging technique was applied to obtain the 3D images. Based on the rendered 3D images at varied loading levels, various crack features and the interactions of the fatigue crack with casting pores were identified and analyzed.Keywords
This publication has 7 references indexed in Scilit:
- Characterization of microshrinkage casting defects of Al–Si alloys by X-ray computed tomography and metallographyInternational Journal of Fatigue, 2012
- X-ray computed tomography vs. metallography for pore sizing and fatigue of cast Al-alloysProcedia Engineering, 2010
- Direct measurement procedure for three-dimensional local crack driving force using synchrotron X-ray microtomographyActa Materialia, 2008
- Direct Observation and Image-Based Simulation of Three-Dimensional Tortuous Crack Evolution inside Opaque MaterialsPhysical Review Letters, 2008
- Application of synchrotron x-ray microtomography to investigate ductile fracture in Al alloysApplied Physics Letters, 2005
- Three dimensional imaging of damage in structural materials using high resolution micro-tomographyNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2005
- A 3D measurement procedure for internal local crack driving forces via synchrotron X-ray microtomographyActa Materialia, 2004