The Effect of Fuel Mass Fraction on the Combustion and Fluid Flow in a Sulfur Recovery Unit Thermal Reactor
Author:
Open Access
- 2 November 2016
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 6 (11) , 331
Abstract
Sulfur recovery unit (SRU) thermal reactors are negatively affected by high temperature operation. In this paper, the effect of the fuel mass fraction on the combustion and fluid flow in a SRU thermal reactor is investigated numerically. Practical operating conditions for a petrochemical corporation in Taiwan are used as the design conditions for the discussion. The simulation results show that the present design condition is a fuel-rich (or air-lean) condition and gives acceptable sulfur recovery, hydrogen sulfide (H2S) destruction, sulfur dioxide (SO2) emissions and thermal reactor temperature for an oxygen-normal operation. However, for an oxygen-rich operation, the local maximum temperature exceeds the suggested maximum service temperature, although the average temperature is acceptable. The high temperature region must be inspected very carefully during the annual maintenance period if there are oxygen-rich operations. If the fuel mass fraction to the zone ahead of the choke ring (zone 1) is 0.0625 or 0.125, the average temperature in the zone behind the choke ring (zone 2) is higher than the zone 1 average temperature, which can damage the downstream heat exchanger tubes. If the zone 1 fuel mass fraction is reduced to ensure a lower zone 1 temperature, the temperature in zone 2 and the heat exchanger section must be monitored closely and the zone 2 wall and heat exchanger tubes must be inspected very carefully during the annual maintenance period. To determine a suitable fuel mass fraction for operation, a detailed numerical simulation should be performed first to find the stoichiometric fuel mass fraction which produces the most complete combustion and the highest temperature. This stoichiometric fuel mass fraction should be avoided because the high temperature could damage the zone 1 corner or the choke ring. A higher fuel mass fraction (i.e., fuel-rich or air-lean condition) is more suitable because it can avoid deteriorations of both zone 1 and heat exchanger tubes. Although a lower fuel mass fraction (i.e., fuel-lean or air-rich condition) can avoid deterioration of zone 1, the heat exchanger tubes may be damaged. This paper provides a guideline for adjusting the fuel mass fraction to reduce the high temperature inside the thermal reactor and to ensure an acceptable sulfur recovery.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan, R.O.C. (MOST 104-2221-E-150-032)
This publication has 9 references indexed in Scilit:
- NUMERICAL ANALYSIS OF THE EFFECTS OF STREAMLINING GEOMETRY AND A VECTOR WALL ON THE THERMAL AND FLUID FLOW IN A SRU THERMAL REACTORTransactions of the Canadian Society for Mechanical Engineering, 2016
- Simulation of hydrogen production from thermal decomposition of hydrogen sulfide in sulfur recovery unitsJournal of Cleaner Production, 2016
- Role of Toluene and Carbon Dioxide on Sulfur Recovery Efficiency in a Claus ProcessEnergy Procedia, 2015
- Effect of Choke Ring Position on Thermal and Fluid Flow in a SRU Thermal ReactorInternational Journal of Mechanical Engineering and Robotics Research, 2015
- Numerical analysis of the combustion and fluid flow in a carbon monoxide boilerInternational Journal of Heat and Mass Transfer, 2013
- Effect of reaction parameters on the quality of captured sulfur in Claus processApplied Energy, 2013
- New experimental data and kinetic rate expression for the Claus reactionChemical Engineering Science, 2000
- Generalized state relationships for scalar properties in nonpremixed hydrocarbon/air flamesCombustion and Flame, 1990
- The numerical computation of turbulent flowsComputer Methods in Applied Mechanics and Engineering, 1974