Efficiency, behavior, and clinical properties of superelastic NiTi versus multistranded stainless steel wires
- 1 September 2012
- journal article
- clinical trial
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 82 (5) , 915-921
Abstract
Objective: To investigate efficiency, behavior, and properties of superelastic NiTi vs multistranded stainless steel wires in Begg and preadjusted edgewise appliance (PEA) under moderate to severe crowding conditions. Material and Methods: Ninety-six participants (48 male, 48 female), aged 12–18 years old (mean age = 15.2 ± 1.95), with moderate (≤ 6 mm; mean = 5.3 ± 0.48) to severe (> 6 mm; mean = 7.9 ± 0.66) initial crowding were distributed into four groups: superelastic NiTi PEA (n = 24), superelastic NiTi Begg (n = 24), multistranded (coaxial) stainless steel PEA (n = 25), and multistranded (coaxial) stainless steel Begg (n = 23). In this study, 0.16-inch superelastic (austenitic active) NiTi and 0.175-inch multistranded (six stranded, coaxial) stainless steel wires were used in a 0.022-inch slot (Roth prescription) PEA and Begg appliance with a follow-up of six weeks. Results: Analysis of variance revealed no significant difference in reduction of crowding between superelastic NiTi PEA and multistranded (coaxial) stainless steel PEA groups, but reduction in crowding was significantly greater in the superelastic NiTi Begg group compared with the multistranded (coaxial) stainless steel Begg group with F (3, 44) = 8.896, P < .001, and effect size (ω) 0.57 in moderate crowding and F (3, 44) = 122.341, P < .001, and effect size (ω) 0.93 in severe crowding. Linear regression demonstrated significant ( P < .05) positive correlation between amount of initial crowding and reduction in crowding in all groups except the multistranded (coaxial) stainless steel Begg group, wherein a negative correlation did exist. Conclusion: Superelastic NiTi performed significantly better than multistranded (coaxial) stainless steel wire in the Begg appliance. However, in PEA, there was no significant difference.Keywords
This publication has 32 references indexed in Scilit:
- Deactivation force-deflection behavior of multistranded stainless steel wiresAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2003
- Photo-elastic stress analysis of initial alignment archwiresEuropean Journal of Orthodontics, 2003
- Clinical comparison and performance perspective of three aligning arch wiresAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1998
- Aligning Archwires, the Shape of Things to Come?—A Fourth and Fifth Phase of Force DeliveryBritish Journal of Orthodontics, 1996
- Properties of superelastic wires and their relevance to orthodontic treatmentEuropean Journal of Orthodontics, 1995
- Elastic property ratios of a triple-stranded stainless steel arch wireAmerican Journal of Orthodontics, 1984
- Maximum forces and deflections from orthodontic appliancesAmerican Journal of Orthodontics, 1983
- Variable-modulus orthodonticsAmerican Journal of Orthodontics, 1981
- The characterization of arch wires for the initial alignment of irregular teethAmerican Journal of Orthodontics, 1981
- Some factors determining the evaluation of forces in orthodonticsAmerican Journal of Orthodontics, 1957