Microstructure and Abrasive Wear Behavior of Fe–Cr–C Hardfacing on Hammer Tips for Sugarcane Shredders
Open Access
Abstract
This study investigates the influence of an austenitic buffer layer on the microstructure, hardness, and abrasive wear resistance of Fe–Cr–C hardfacing applied to high-chromium white cast iron (HCWCI) hammer tips used in sugarcane shredders. Hardfacing was performed by shielded metal arc welding with two Fe–Cr–C layers deposited directly on the HCWCI substrate and with an austenitic buffer layer followed by an Fe–Cr–C hardfacing layer. Microstructural characterization was carried out using optical microscopy, scanning electron microscopy with energy-dispersive X-ray spectroscopy, while hardness profiles were determined by micro-Vickers testing. Abrasive wear behavior was evaluated using a dry sand–rubber wheel test according to ASTM G65. The non-buffered hardfacing layer exhibited a hypereutectic Fe–Cr–C microstructure consisting of coarse primary chromium carbides, resulting in high hardness values of approximately 840 HV. In contrast, the buffered sample showed an austenite-rich matrix with finer eutectic carbides and reduced hardness of around 600 HV. Abrasive wear tests of the non-buffered sample showed a lower mass loss, whereas the buffered sample exhibited a substantially higher mass loss. These results demonstrate that Fe–Cr–C hardfacing without a buffer layer provides superior wear resistance.Keywords
Funding Information
- Walailak University (WU69231)
This publication has 62 references indexed in Scilit:
- Interface Evolution of Multilayer Hardfacing Structure on Quenched and Tempered Steel Using GTAW with Magnetic Arc OscillationMetallurgical and Materials Transactions B, 2026
- A Comparative Wear Analysis of Tool Steels: An Evaluation Based on ASTM G65 and G195 Testing MethodsJournal of Materials Engineering and Performance, 2025
- Microstructural and wear investigation of FeCrC and FeCrC-NbB hardfacing alloys deposited with FCAW-SThe International Journal of Advanced Manufacturing Technology, 2024
- Simulation of the Kinetics of Microstructure Evolution during Destabilization and Tempering of a High-Chromium White Cast IronJournal of Materials Engineering and Performance, 2024
- Premature Failure Analysis of the High-Speed Steel Work Roll of Hot Strip MillJournal of Failure Analysis and Prevention, 2024
- Current Situation and Trends in Thailand's Sugarcane SectorSugar Tech, 2024
- Correlating Hardness and Welding Dilution with the Abrasion Mass Loss of Hardfacings Welded with Different Currents and PolaritiesMetallurgist, 2018
- Effect of Boron on the Hot Ductility Behavior of a Low Carbon Advanced Ultra-High Strength Steel (A-UHSS)Metallurgical and Materials Transactions A, 2013
- The Microstructure and Abrasive Wear Resistance of Fe–Cr–C Hardfacing Alloys with the Composition of Hypoeutectic, Eutectic, and Hypereutectic at $ \frac{Cr}{C} = 6 $Tribology Letters, 2011
- Effect of Destabilization Heat Treatments on the Microstructure of High-Chromium Cast Iron: A Microscopy Examination ApproachJournal of Materials Engineering and Performance, 2009