Fundamental characterisation of CdZnTe (CZT) and CdTe as sensor materials for the JUNGFRAU charge-integrating ASIC

Authors:

Abstract
The upgraded Swiss Light Source (SLS 2.0) increases the need for high-Z detector systems with improved detection efficiency for hard X-rays compared with silicon. Two candidate high-Z sensor materials, cadmium zinc telluride (CZT) and cadmium telluride (CdTe), have undergone fundamental characterisation at PSI using the JUNGFRAU readout ASIC. Two variants of each material were investigated: Schottky and Ohmic CdTe, and spectroscopic and high-flux CZT. Measurements include current-voltage characteristics, pixel-resolved leakage current and noise, flat-field response, and energy resolution. Both CZT sensors exhibited a very low mean leakage current of 0.60 pA and 0.18 pA per pixel for spectroscopic and high-flux CZT, respectively. Ohmic CdTe showed a substantially higher mean leakage current of 65.81 pA per pixel, while Schottky CdTe showed much lower mean leakage current (0.62 pA) but contained a significant population of high-leakage-current pixels. At 59.54 keV, both CZT sensors achieved an energy resolution of approximately 3.5 keV FWHM using 3×3 clusters, compared with 4.3 keV for Ohmic CdTe and 5.9 keV for Schottky CdTe. Ohmic CdTe additionally required approximately two hours after biasing for its leakage current and pedestal to stabilise. Both CZT sensors could be operated at full duty cycle with a 500 μs exposure time, with only a small reduction in available dynamic range. Overall, the CZT sensors showed the most favourable performance of the devices investigated, although further measurements across a larger number of sensors are required to assess sensor-to-sensor variation and production yield.

This publication has 16 references indexed in Scilit: