The Impact of Direct-Current Electro-Treatment on the Microstructure and Mechanical Behavior of Cold-Rolled 2014 Aluminum Alloys
Open Access
- 13 November 2025
- journal article
- research article
- Published by Springer Nature in JOM
- Vol. 78 (6) , 5369-5391
Abstract
Electrically assisted post-processing is proposed as an energy-efficient alternative to conventional thermal annealing for tailoring the mechanical properties of cold-rolled AA2014 aluminum alloys. Cold-rolled strips were subjected to direct current at current densities ranging from 1.4 to 2.0 × 10 4 A/cm 2 for 60 min, and the resulting microstructural evolutions were characterized by electron backscatter diffraction, focusing on grain microstructures, residual strain, grain-boundary characteristics, and textures. The results revealed a distinct transition from recovery-dominated processes at relatively low current densities (1.4–1.6 × 10 4 A/cm 2 ) to recrystallization and grain growth accompanied by texture randomization at higher current densities (1.8–2.0 × 10 4 A/cm 2 ). Significant micro-hardness reductions, up to 48.7% relative to the cold-rolled state, were achieved, reaching values comparable to the solution-treated benchmark at 500°C. Thermal benchmark experiments further demonstrated that the observed microstructural transformation was attributed to the synergistic thermal and athermal effects, highlighting that Joule heating alone could not reproduce the extent of recrystallization. These findings confirm electro-treatment (ET) as a potential route for efficient microstructure control and mechanical property tailoring in AA2014, offering both performance benefits and reduced energy consumption of 95.7% compared to conventional thermal annealing treatment for advanced manufacturing applications.Keywords
Funding Information
- National Science and Technology Council (NSTC 113-2221-E-011-027)
- National Taiwan University of Science and Technology
This publication has 64 references indexed in Scilit:
- Numerical simulation on an effect of backing plates on joint temperature and weld quality in air and immersed FSW of AA2014-T6The International Journal of Advanced Manufacturing Technology, 2018
- Influence of Annealing on Microstructural Evolution, Precipitation Sequence, and Fracture Toughness of Cryorolled Al–Cu–Si AlloyMetallography, Microstructure, and Analysis, 2016
- Evolution of recrystallization texture in a 0.78 wt.% Cr extra-low-carbon steel after warm and cold rollingActa Materialia, 2011
- Recrystallization kinetics and microstructure evolution during annealing of a cold-rolled Fe–Mn–C alloyActa Materialia, 2011
- Optimizing the strength and ductility of fine structured 2024 Al alloy by nano-precipitationActa Materialia, 2007
- Determining hardness of thin films in elastically mismatched film-on-substrate systems using nanoindentationActa Materialia, 2006
- Electromigration failure mechanisms in bamboo-grained Al(Cu) interconnectionsThin Solid Films, 1995
- Texture development in Al-1.8 wt% Cu depending on the precipitation state—II. Recrystallization texturesActa Metallurgica et Materialia, 1995
- The effect of microstructure on the resistance to electromigration of AlCu thin film conductorsThin Solid Films, 1991
- An evaluation of the contributions of skin, pinch and heating effects to the electroplastic effect in titatniumMaterials Science and Engineering, 1980