Discharge Regimes of Polydisperse Powders through Conical Hoppers under Positive Flow Conditions
- 21 November 2008
- journal article
- research article
- Published by Taylor & Francis in Particulate Science and Technology
- Vol. 26 (6) , 551-562
Abstract
Discharge characteristics of polydisperse powders through a conical hopper were experimentally investigated by observing the solids discharge regimes under different positive pressure differences (i.e., ΔP > 0) and also measuring the corresponding solids discharge rates. The observations and measurements were systematically conducted at least four diameters of hopper orifice (2.5 mm ≤ Do ≤ 30.0 mm) under five positive ΔP values (0 Pa ≤ ΔP ≤ 1405 Pa) for the test powders: river sand, zeolite, fertilizer, and sawdust. Effects of positive ΔP on both discharge regime and solids discharge rate are first predicted for different orifice diameters and test powders in this study. One of the novel results on the discharge regime is that increase of positive ΔP value up to a critical value conserves or successively stabilizes the discharge regime observed when ΔP = 0 (i.e., for gravity flow condition) through the same hopper. However, the additional increase of positive ΔP over this critical value destabilizes the discharge regime, as in conformity with the effect of increase in negative ΔP cited in the literature.Keywords
This publication has 21 references indexed in Scilit:
- Discharge Characteristics of Polydisperse Powders through Conical Hoppers. Part 2: Predictions for Coarse, Granular, Free Flowing PowdersParticulate Science and Technology, 2006
- Flow of granules through cylindrical hopperPowder Technology, 2005
- Discharge Characteristics of Polydisperse Powders through Conical Hoppers. Part 1: Predictions for Fine, Granular, Free Flowing PowdersParticulate Science and Technology, 2004
- On the role and the origin of the gas pressure gradient in the discharge of fine solids from hoppersChemical Engineering Science, 2003
- Experimental study on the hung-up regime of a hopper-standpipe system for a Geldart-D powderChemical Engineering and Processing - Process Intensification, 2003
- The use of bulk density measurements as flowability indicatorsPowder Technology, 1999
- Study on the flow of fine powders from hoppers connected to a moving-bed standpipe with negative pressure gradientPowder Technology, 1999
- Distribution of gas pressure inside a hopper discharging fine powdersChemical Engineering Science, 1997
- Air-impeded discharge of fine particles from a hopperPowder Technology, 1977
- The flow of granular solids through orificesChemical Engineering Science, 1961