Simulation and Comprehensive Analysis of Fluoride Fiber SPR Sensor With Multilayer Variants of 2D Materials (Graphene and MoS2) Under Optimum Radiation Damping in NIR
- 13 June 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 19 (19) , 8775-8780
Abstract
The performance of multiple variants of fluoride fiber plasmonic sensor is simulated and analyzed under optimum radiation damping (ORD) in terms of coordinated tuning of Ag layer thickness (dAg) and near infrared (NIR) wavelength (λ). The sensor variants are in terms of number of monolayers (N: 1 -5) of graphene and MoS2. The dispersion relations of all constituent layers along with transfer matrix method is utilized for sensor simulation. The sensor’s performance is evaluated in terms of figure of merit (FOM) that takes into account the shift and width of fiber power loss resonance curves originating under the plasmonic modulation. Further totality is added to performance evaluation by combining the FOM with signal scattering and power loss ratio factors. The simulation results and their comprehensive analysis indicate that a combination of λ = 925.3 nm, dAg = 48.4 nm, and MoS2 monolayer can provide considerably enhanced performance in terms of maximum FOM, small light signal scattering (and analyte photodamage), and large power loss ratio (with respect to reference resonance curve). The FOM achievable with this sensor is 4.5 times better than the previously reported chalcogenide fiber plasmonic sensor under its corresponding ORD. A deeper analysis of the proposed fluoride sensor predicts that even smaller signal scattering (and photodamage) along with nearly identical power loss ratio and FOM can be achieved with the sensor variant based on MoS2 bilayer.Keywords
Funding Information
- Council of Scientific and Industrial Research, India (03(1441)/18/EMR-II)
- MHRD
This publication has 32 references indexed in Scilit:
- Linear refractive index and absorption measurements of nonlinear optical liquids in the visible and near-infrared spectral regionOptical Materials Express, 2012
- Surface plasmon resonance based fiber optic sensor for the detection of low water content in ethanolSensors and Actuators B: Chemical, 2011
- Atomically Thin: A New Direct-Gap SemiconductorPhysical Review Letters, 2010
- Emerging Photoluminescence in Monolayer MoS2Nano Letters, 2010
- Fiber-Optic Chemical Sensors and BiosensorsAnalytical Chemistry, 2008
- Analysis of the performance of interferometry, surface plasmon resonance and luminescence as biosensors and chemosensorsAnalytica Chimica Acta, 2006
- Surface Plasmon Resonance Near-Infrared SpectroscopyAnalytical Chemistry, 2004
- Surface plasmon resonance sensors based on diffraction gratings and prism couplers: sensitivity comparisonSensors and Actuators B: Chemical, 1999
- Evaluation of refractive-index and material dispersion in fluoride glassesApplied Optics, 1994
- Kramers-Kronig analysis of the reflectivity spectra of 2H-MoS2, 2H-MoSe2and 2H-MoTe2Journal of Physics C: Solid State Physics, 1979