A Novel Zero Dead-Time PWM Method to Improve the Current Distortion of a Three-Level NPC Inverter
Open Access
- 19 December 2020
- journal article
- research article
- Published by MDPI AG in Electronics
- Vol. 9 (12) , 2195
Abstract
This paper proposes a novel pulse width modulation (PWM) for a three-level neutral point clamped (NPC) voltage source inverter (VSI). When the conventional PWM method is used in three-level NPC VSI, dead time is required to prevent a short circuit caused by the operation of complementary devices on the upper and lower arms. However, current distortion is increased because of the dead time and it can also cause a voltage unbalance in the dc-link. To solve this problem, we propose a zero dead-time width modulation (ZDPWM) which does not require dead time used in complementary operation. The proposed technique applies the offset voltage to the space vector pulse width modulation (SVPWM) reference voltage for the same modulation index (MI) as the conventional SVPWM, but any complementary switching operation needs dead time. In addition, the proposed method is divided into four operation sections using the reference voltage and phase current to operate switching devices which flow the current depending on the section. This ZDPWM method is simply implemented by carrier and reference voltage that reduce the current distortion, because complementary operation that needs dead time is not implemented. However, the operation section is delayed due to the sampling delay that occurs during the experiment. Therefore, in this paper, we conduct a modeling of sampling delay to improve the delay of operation section. To verify the principle and feasibility of the proposed ZDPWM method, a simulation and experiment are implemented.Keywords
This publication has 29 references indexed in Scilit:
- An Enhanced Control Scheme Based on New Adaptive Filters for Cascaded NPC/H-Bridge SystemEnergies, 2018
- Design and Comparison of Cascaded H-Bridge, Modular Multilevel Converter, and 5-L Active Neutral Point Clamped Topologies for Motor Drive ApplicationsIEEE Transactions on Industry Applications, 2017
- Direct Power Control for Three-Phase Two-Level Voltage-Source Rectifiers Based on Extended-State ObservationIEEE Transactions on Industrial Electronics, 2016
- Adaptive Dead-Time Compensation for Grid-Connected PWM Inverters of Single-Stage PV SystemsIEEE Transactions on Power Electronics, 2013
- Carrier-Based Neutral Point Potential Regulator With Reduced Switching Losses for Three-Level Diode-Clamped InverterIEEE Transactions on Industrial Electronics, 2013
- Dead Time Compensation Method for Voltage-Fed PWM InverterIEEE Transactions on Energy Conversion, 2009
- A Discontinuous PWM Method for Balancing the Neutral Point Voltage in Three-Level Inverter-Fed Variable Frequency DrivesIEEE Transactions on Energy Conversion, 2008
- Multilevel inverters: a survey of topologies, controls, and applicationsIEEE Transactions on Industrial Electronics, 2002
- The analysis and compensation of dead-time effects in PWM invertersIEEE Transactions on Industrial Electronics, 1991
- A New Neutral-Point-Clamped PWM InverterIEEE Transactions on Industry Applications, 1981