Investigation on the influence of particle size on the microstructure and properties of laser-cladded CuSn12 coatings
- 7 April 2025
- journal article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 37 (2)
Abstract
This study utilized laser cladding technology to fabricate copper alloy cladding layers on the surface of 42CrMo steel using CuSn12 powder with varying particle sizes (25–38, 45–75, and 75–150 μm). The influence of powder particle size on the morphology, microstructure, microhardness, and wear resistance of the cladding layer was investigated. Morphological analysis revealed that the cross section of the cladding layer produced with fine particles contained a significant number of pores distributed at the bottom and upper-middle regions of the layer; the layer fabricated with medium-sized particles exhibited a limited number of pores, primarily at the bottom; and the layer produced with coarse particles had a few unfused pores located at the interface with the substrate. Microhardness and wear resistance varied with changes in particle size, with the medium-sized particle cladding layer demonstrating superior performance in all evaluated properties.Keywords
Funding Information
- Natural Science Foundation of Zhejiang Province (LZ22E030003)
This publication has 38 references indexed in Scilit:
- Selective Laser Melting of Cu–10Sn–0.4P: Processing, Microstructure, Properties, and Brief Comparison with Additively Manufactured Cu–10SnAdvanced Engineering Materials, 2021
- Role of powder particle size on laser powder bed fusion processability of AlSi10mg alloyAdditive Manufacturing, 2021
- Laser 3D printing of complex copper structuresAdditive Manufacturing, 2020
- Electrical resistivity of pure copper processed by medium-powered laser powder bed fusion additive manufacturing for use in electromagnetic applicationsAdditive Manufacturing, 2019
- Influence of Particle Size on Laser Absorption and Scanning Track Formation Mechanisms of Pure Tungsten Powder During Selective Laser MeltingEngineering, 2019
- Limits and solutions in processing pure Cu via selective laser melting using a high-power single-mode fiber laserThe International Journal of Advanced Manufacturing Technology, 2019
- Selective Laser Melting of Pure CopperJOM, 2017
- Additive manufacturing of metalsActa Materialia, 2016
- Laser powder-bed fusion additive manufacturing: Physics of complex melt flow and formation mechanisms of pores, spatter, and denudation zonesActa Materialia, 2016
- Fabrication of Ti-6Al-4V Scaffolds by Direct Metal DepositionMetallurgical and Materials Transactions A, 2008