Analysis and design of dynamic comparators in ultra-low supply voltages
- 1 May 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 255-258
Abstract
The need for ultra-low power and area-efficient analog-to-digital converters (ADCs) is pushing towards the use of low-voltage (LV) dynamic clocked comparators to maximize power efficiency and speed. In this paper, a delay analysis for a conventional body-driven LV dynamic comparator is presented. Then based on the analysis results, the circuit of a conventional body-driven comparator is modified for fast operation even in small supply voltages. Simulation results in 90nm CMOS technology reveal that comparator delay time is remarkably reduced. The maximum clock frequency of the proposed comparator can be increased to 333 MHz and 50 MHz at supply voltages of 0.5V and 0.35V, while consuming 2.3μW and 184nW, respectively. The standard deviation of the input-referred offset voltage is 5.1mV at 0.5V supply.Keywords
This publication has 9 references indexed in Scilit:
- A new rail-to-rail ultra low voltage high speed comparator2013
- Analysis and Design of a Low-Voltage Low-Power Double-Tail ComparatorIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2013
- A sub-1 Volt 10-bit supply boosted SAR ADC design in standard CMOSAnalog Integrated Circuits and Signal Processing, 2010
- Supply boosting technique for designing very low-voltage mixed-signal circuits in standard CMOS2010
- A 65nm CMOS comparator with modified latch to achieve 7GHz/1.3mW at 1.2V and 700MHz/47µW at 0.6V2009
- A Double-Tail Latch-Type Voltage Sense Amplifier with 18ps Setup+Hold Time2007
- A 40-Gb/s CMOS clocked comparator with bandwidth modulation techniqueIEEE Journal of Solid-State Circuits, 2005
- 1-bit quantiser with rail to rail input range for sub-1 V ΔΣ modulatorsElectronics Letters, 2003
- Body-driving as a low-voltage analog design technique for CMOS technology2002