Experimental Study of Linear Profile Modification in Spur Gear Leg
- 17 May 2024
- journal article
- research article
- Published by International Journal of Technology in International Journal of Technology
- Vol. 15 (3) , 665-676
Abstract
Gears with the involute profile are assumed to be rigid and good at producing mating gear. They are also deformable and deflectable, indicating additional space is required to avoid interference from the unpredictable shaft, misalignment, and dynamic factors. In addition, load and rotational speed cause frequent mild to severe interference leading to a significant reduction in its lifespan. This study conducted an experimental comparison between standard and modification involute gear profiles in a ratio of 1:2 to reduce interference. It was carried out using 18 pinion teeth with a 72 mm base diameter at three and four levels of torque load and speed. The load was also mounted a strain gauge on pinion gears to conduct strain measurement on the gear leg. Finally, it was applied using a mechanical brake measured by a dynamic torque meter. The experimental test obtained microstrain when the modified spur gear contacted for 3.04 – 6.67 milliseconds depending on the rotation speed and torque load. Modification of the linear involute profile significantly reduced the tooth leg strain at the rate of 5.6% to 13.99%. Meanwhile, the maximum microstrain reduction of 13.99% occurred at a speed of 1100 rpm and a torque load of 65%.Keywords
This publication has 18 references indexed in Scilit:
- Research on the meshing characteristics of asymmetric gears considering the tooth profile deviationMechanism and Machine Theory, 2022
- Experimental investigation of spur gear strength using photoelasticityProcedia Structural Integrity, 2018
- Internal spur gear root bending stress: A comparison of ISO 6336:1996, ISO 6336:2006, VDI 2737:2005, AGMA, ANSYS finite element analysis and strain gauge techniquesProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2018
- Dynamic modeling of gearbox faults: A reviewMechanical Systems and Signal Processing, 2018
- On optimal tooth profile modification for reduction of vibration and noise in spur gear pairsMechanism and Machine Theory, 2016
- Dynamic tooth root strains and experimental correlations in spur gear pairsMechanism and Machine Theory, 2016
- Analytical investigation of tooth profile modification effects on planetary gear dynamicsMechanism and Machine Theory, 2013
- Static/dynamic contact FEA and experimental study for tooth profile modification of helical gearsJournal of Mechanical Science and Technology, 2012
- Influence of dynamic behaviour on elastohydrodynamic lubrication of spur gearsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2011
- Influence of Tip Relief Modification on the Wear of Spur Gears with Asymmetric TeethTribology Transactions, 2008