Online Determining Heat Transfer Coefficient for Monitoring Transient Thermal Stresses
Open Access
Abstract
This paper proposes an effective method for determining thermal stresses in structural elements with a three-dimensional transient temperature field. This is the situation in the case of pressure elements of complex shapes. When the thermal stresses are determined by the finite element method (FEM), the temperature of the fluid and the heat transfer coefficient on the internal surface must be known. Both values are very difficult to determine under industrial conditions. In this paper, an inverse space marching method was proposed for the determination of the heat transfer coefficient on the active surface of the thick-walled plate. The temperature and heat flux on the exposed surface were obtained by measuring the unsteady temperature in a small region on the insulated external surface of a pressure component that is easily accessible. Three different procedures for the determination of the heat transfer coefficient on the water-spray surface were presented, with the division of the plate into three or four finite volumes in the normal direction to the plate surface. Calculation and experimental tests were carried out in order to validate the method. The results of the measurements and calculations agreed very well. The computer calculation time is short, so the technique can be used for online stress determination. The proposed method can be applied to monitor thermal stresses in the components of the power unit in thermal power plants, both conventional and nuclear.Keywords
This publication has 19 references indexed in Scilit:
- Fatigue and thermal stress analysis of submerged steel pipes using ANSYS softwareOcean Engineering, 2019
- An experimental method to quantify local air-side heat transfer coefficient through mass transfer measurements utilizing color change coatingsInternational Journal of Heat and Mass Transfer, 2019
- Analysis of the heat transfer for processes of the cylinder heating in the heat-treating furnace on the basis of solving the inverse problemInternational Journal of Thermal Sciences, 2019
- Thermal and stress analyses of a novel coated steam dual pipe system for use in advanced ultra-supercritical power plantInternational Journal of Pressure Vessels and Piping, 2019
- Mathematical model of a supercritical power boiler for simulating rapid changes in boiler thermal loadingEnergy, 2019
- Thermal Stress and Cyclic Stress Analysis of a Vertical Water-Cooled Wall at a Utility Boiler under Flexible OperationEnergies, 2019
- Redistribution of residual stress by thermal shock in reactor pressure vessel steel clad with nickel alloyInternational Journal of Pressure Vessels and Piping, 2019
- Lifetime Assessment of Combined Cycles for Cogeneration of Power and Heat in Offshore Oil and Gas InstallationsEnergies, 2017
- Measurement of local heat/mass transfer coefficients on a dimple using naphthalene sublimationInternational Journal of Heat and Mass Transfer, 2011
- Measurement of heat transfer coefficients by nuclear magnetic resonanceMagnetic Resonance Imaging, 2008