Design and study of a linear actuator using an analytical approach and the 3D FEM
Authors:
- 14 August 2007
- journal article
- Published by Emerald Publishing in COMPEL - The international journal for computation and mathematics in electrical and electronic engineering
- Vol. 26 (4) , 1005-1016
Abstract
Purpose – Electromagnetic actuators, with very specific features for industrial processes, are needed much more for an increase in reliability and dynamic. To reach the wanted features, the actuator has to be designed and its performance has to be quantified with good accuracy and reasonable computation time. The purpose of this paper is to present the design and the study of a permanent magnet linear actuator. Design/methodology/approach – The first design of the permanent magnet linear actuator has been introduced from electromechanical considerations. Then, both models utilized to study the actuator are presented: the permeance network model (PNM) and the 3D finite element model. These models are used to quantify the performance of the prototype. Owing to its speed, the influence of geometric parameters on the performances are studied by the PNM. Then, both models are used to perform calculations on global variables. A prototype of the designed actuator has been built up and the results obtained by both models are compared with the measurements. Findings – The developed model has been used to study the behaviour of the designed actuator. Using the 3D-FEM, the local phenomena have been highlighted as the magnetic flux density and the induced current. Then, global variables as the no load fluxes and the forces at load have been determined. The results obtained by both models have been compared together and show a good agreement. They are also very close to the measurements achieved on the prototype constructed. Originality/value – This paper shows that it is possible to use a PNM model to design a permanent magnet linear actuator with a relative good accuracy. The PNM developed does not permit one to calculate the cogging forces and does not take into account the induced currents but it gives accurate results when the interest is focused only on the magnetostatic load operating. The comparison with the results given by 3D-FEM and to the measurements shows a good agreement.Keywords
This publication has 7 references indexed in Scilit:
- High-acceleration linear drives: dimensioning and constraints relative to electromagnetic valves2005
- Modeling of a linear pm machine including magnetic saturation and end effects: maximum force-to-current ratioIEEE Transactions on Industry Applications, 2003
- Modelling the performance of the vernier hybrid machineIEE Proceedings - Electric Power Applications, 2003
- Synthesis of high performance PM motors with concentrated windingsIEEE Transactions on Energy Conversion, 2002
- Model with source terms in the constitutive relationshipIEEE Transactions on Magnetics, 2002
- Three dimensional eddy current calculation using reluctance-conductance network formed by means of FE methodIEEE Transactions on Magnetics, 2000
- Numerical model to discretize source fields in the 3D finite element methodIEEE Transactions on Magnetics, 2000