Experimental Study on Fabrication of Al-Al2O3/Grp Metal Matrix Composites
Authors:
- 19 May 2010
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 44 (25) , 3069-3079
Abstract
In this study aluminum (Al-6070)/alumina (Al2O3), and Al-6070/ graphite (Gr) reinforced particles metal-matrix composites (MMCs) are fabricated by melt-stirring technique. The MMCs bars and plates are prepared with varying the reinforced particles volume fraction ranging from 5% to 15%. The average reinforced particles size of alumina (Al2O 3) and graphite (Grp) are 23 μm and 53 μm, respectively. The stirring process was carried out at 200 rev/min rotating speed by graphite impeller for 15 min. The microstructure and mechanical properties are investigated on prepared MMCs. It was observed that the hardness of the composite is increased with increasing of reinforced particle volume fraction. The tensile strength and impact strength both are decreased with rising of reinforced volume fraction. The prepared composite plates are welded by gas welding with Al-Si-base filler metal. Rockwell hardness test was conducted and presented the test result for un-welded and welded zone.Keywords
This publication has 13 references indexed in Scilit:
- Microstructure and properties of tetrapod-like ZnO whiskers reinforced Al matrix compositeJournal of Alloys and Compounds, 2008
- Mechanical properties of the as-cast quartz particulate reinforced LM6 alloy matrix compositesJournal of Materials Processing Technology, 2008
- Development of a novel hybrid aluminum-based composite with enhanced propertiesJournal of Materials Processing Technology, 2006
- Synthesis and characterization of free standing, bulk Al/SiCp functionally gradient materials: effects of different stirrer geometriesMaterials Research Bulletin, 2003
- Particle distribution in cast metal matrix composites—Part IJournal of Materials Processing Technology, 2002
- Metal matrix composites: production by the stir casting methodJournal of Materials Processing Technology, 1999
- Casting of SiC reinforced metal matrix compositesJournal of Materials Processing Technology, 1997
- Microstructure evolution during solidification of DRMMCs (Discontinuously reinforced metal matrix composites): State of artJournal of Materials Processing Technology, 1997
- The stress/strain behavior of aluminum matrix composites with discontinuous reinforcementsActa Metallurgica et Materialia, 1991
- Microstructural aspects of aluminium-silicon carbide particulate composites produced by a casting methodMaterials Science and Engineering: A, 1989