Operation of the Electronic Current Transformer for Transformation of Distorted Current Higher Harmonics
Open Access
Abstract
This paper evaluates an electronic current transformer’s wideband accuracy in the transformation of distorted current harmonics. The tests were performed in the range of frequencies from 50 Hz to 5 kHz. The utmost importance was dedicated to the transformation of the low-order higher harmonics. The novelty of this paper involves the analysis of the self-generation of the third and fifth higher harmonics caused by the nonlinearity of magnetic core magnetization characteristics. Therefore, what is considered new in this investigation is that this phenomenon has a significant influence on values of current errors and phase displacements despite the presence of the operational amplifiers and the Hall sensors in the output circuits. Another important factor to consider is the influence of the RMS value of the primary current and output load of the ECT on wideband accuracy. To show the backgrounds of the performed laboratory studies, we also discuss the operation principles of the ECTs with closed and open feedback loops. The accuracy of the tested ECT deteriorated—as with the inductive CT—by the self-generation phenomenon. This resulted in rapid changes in the values of current errors and phase displacements determined for the low-order higher harmonics.Keywords
This publication has 25 references indexed in Scilit:
- Calibration of Current Transformers in distorted conditionsJournal of Physics: Conference Series, 2018
- Inductive current transformer accuracy of transformation for the PQ measurementsElectric Power Systems Research, 2017
- A Redundancy Mechanism Design for Hall-Based Electronic Current TransformersEnergies, 2017
- New Electronic Current Transformer With a Self-Contained Power SupplyIEEE Transactions on Power Delivery, 2014
- Wide Frequency Operation of the Inductive Current Transformer with Ni80Fe20 Toroidal CoreElectric Power Components and Systems, 2014
- Low cost measurement equipment for the accurate calibration of voltage and current transducers2014
- Electronic Voltage and Current Transformers Testing DeviceSensors, 2012
- High-Fidelity Low-Cost Electronic Current Sensor for Utility Power MeteringIEEE Transactions on Power Delivery, 2011
- Design of a Hall Effect Current Microsensor for Power NetworksIEEE Transactions on Smart Grid, 2011
- A Simple Method for the Calibration of Traditional and Electronic Measurement Current and Voltage TransformersIEEE Transactions on Instrumentation and Measurement, 2009