Modelling method for bending stiffness of bolted flange joint with spigot and analysis of rotor vibration characteristics
Authors:
- Yu LiYLYu Li
- Siji WangSWSiji Wang
- Haitao GuanHGHaitao Guan
- Liang HongLHLiang Hong
- Qingyang ShenQSQingyang Shen
- Quankun LiQLQuankun Li
- Lu ZhaoLZLu Zhao
- Ruixian MaRuixian Ma
- Zhongliang XieZhongliang Xie
Preprint
- 27 February 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
To meet the rapid iteration requirements of the bolted rotor system for the next-generation aero-engine in the conceptual design phase, the bending stiffness model of the bolted joint is required to have the characteristics of high accuracy and easy solvability. A new analytical model of bending stiffness for bolted flange joint with spigot considering all parameters is established based on the theory of plates and shells, and the effects of preload and preload unevenness on the bending stiffness are analyzed. By performing a comparison study with the finite contact element model, the maximal calculation error of the bending stiffness is approximately 6.83%, and the time required to calculate the bending stiffness once is reduced from 7 minutes to 5e-5 second, the accuracy and efficiency of the proposed model is validated. After that, an equivalent method for characterizing bolted joint using virtual shaft segment is proposed, and a dynamical model of the bolted rotor system is developed, in which the proposed bending stiffness model is introduced. The influence of preload and preload unevenness on the vibration characteristics of the bolted rotor system are analyzed by combining numerical calculation and experimental investigation. The results show that increasing preload can narrow the nonsynchronous response interval of the bolted rotor system and reduce the proportion of strain energy for the bolted joint, the amplitude of subcritical self-excited vibration decreases with the reduction of preload unevenness.Keywords
This publication has 25 references indexed in Scilit:
- Dynamic modelling and stability analysis of aero-engine rotor system considering aerodynamicsAerospace Science and Technology, 2024
- Investigations on the modal vibration caused by bolted joint interface contact in the rotor-AMBs systems: Modelling and experimentationApplied Mathematical Modelling, 2024
- Dynamic characteristics of a rod-fastening rotor system with tie rod bolt looseningNonlinear Dynamics, 2023
- Frequency spectrum analysis of the rotor system with bolted joint: Numerical and experimental verificationApplied Mathematical Modelling, 2023
- Bifurcation studies of a bolted-joint rotor system subjected to fixed-point rubbing faultNonlinear Dynamics, 2022
- Dynamic modelling and vibration characteristics analysis for the bolted joint with spigot in the rotor systemApplied Mathematical Modelling, 2021
- Analytical lump model for the nonlinear dynamic response of bolted flanges in aero-engine casingsMechanical Systems and Signal Processing, 2019
- Bolt loosening at rotating joint interface and its influence on rotor dynamicsEngineering Failure Analysis, 2016
- Modeling the dynamics of mechanical jointsMechanical Systems and Signal Processing, 2011
- On the Iwan models for lap-type bolted jointsInternational Journal of Non-Linear Mechanics, 2011