Passive Thermal Management of Cylindrical Lithium-Ion Cells Using Additively Manufactured Polymer Housings
Open Access
Abstract
Lithium-ion batteries are widely used in modern energy storage systems; however, increasing power demand makes thermal management a critical challenge, particularly for cylindrical cells operating under high discharge conditions. This study investigates the thermal behavior of cylindrical lithium-ion cells equipped with additively manufactured polymer housings produced by fused filament fabrication (FFF). PLA, PCTG, flame-retardant PLA (FG_PLA), and ASA housings were evaluated using Samsung 50S, Molicel P42A, and Reliance RS50 cells under 1C–5C discharge rates. Surface temperatures were measured at multiple locations to assess heat transfer through the housing structures. All investigated housings reduced the measured maximum cell surface temperature compared with the housing-free configuration, particularly at high discharge rates. PLA exhibited the greatest thermal buffering effect, while PCTG showed the highest estimated conductive heat-transfer rate and a more uniform temperature evolution across the housing. ASA demonstrated stable thermal behavior, with thin housings generally showing a greater measured temperature reduction than thick configurations. In contrast, flame-retardant PLA provided the smallest temperature reduction. Wall thickness influenced the transient thermal response but did not consistently result in a greater measured temperature reduction. At elevated temperatures, partial deformation of some polymer housings was observed. The results demonstrate that FFF-manufactured polymer housings can substantially modify the transient thermal response of cylindrical lithium-ion cells, while material selection and housing geometry remain key design parameters for passive thermal management applications.Keywords
Funding Information
- EKÖP-25-4-II-SZE-88 university research fellowship program of the Ministry for Culture and Innovation from the source of the National Research, Development and Innovation Fund
This publication has 28 references indexed in Scilit:
- Phase change materials in thermal management of Li-ion batteries: A state-of-the-art reviewJournal of Energy Storage, 2025
- A review of thermal management systems of lithium-ion batteries used in electric vehiclesJournal of Traffic and Transportation Engineering (English Edition), 2025
- Degradation Mechanisms of Electrodes Promotes Direct Regeneration of Spent Li‐Ion Batteries: A ReviewAdvanced Materials, 2024
- Influence of cell dimensions and housing material on the energy density and fast-charging performance of tabless cylindrical lithium-ion cellsEnergy Storage Materials, 2023
- Numerical investigation on thermal characteristics of a liquid-cooled lithium-ion battery pack with cylindrical cell casings and a square ductJournal of Energy Storage, 2022
- Numerical Study of Flow and Heat Transfer Performance of 3D-Printed Polymer-Based Battery Thermal ManagementInternational Journal of Heat and Mass Transfer, 2020
- Development of a pyrolysis model for an intumescent flame retardant system: Poly(lactic acid) blended with melamine and ammonium polyphosphateComposites Part B: Engineering, 2020
- Polymeric hollow fibers: A supercompact cooling of Li-ion cellsInternational Journal of Thermal Sciences, 2019
- Thermal runaway mechanism of lithium ion battery for electric vehicles: A reviewEnergy Storage Materials, 2018
- A comprehensive review of lithium-ion batteries used in hybrid and electric vehicles at cold temperaturesApplied Energy, 2016