Evaluating Aeolian Vibration Performance of High-Temperature Low-Sag OHL Conductors
- 16 July 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 37 (3) , 1775-1784
Abstract
High-Temperature Low-Sag (HTLS) conductor technologies are often implemented, among many approaches, for optimizing the overhead lines’ utilization. The advancements of HTLS conductors are based on the differences in core and aluminum properties and installation procedures. This non-linear conductor behavior, although considered in the sag-tension calculations, by implementing the knee-point temperature, is often omitted from the aeolian vibration calculations. To understand the implications of the complex HTLS conductor structure on vibrations, a new calculation approach is proposed in this paper to quantify the effect of installation and operating conditions on the performance of any HTLS conductor. The proposed method conceives a prediction lay area that estimates where the actual field data are expected to lay and is validated with good accuracy against the field data from ACSR, ACCC, and GZTACSR. The developed model enables the prediction of non-homogeneous (composite) conductors and should be implemented at above knee-point operating temperatures with zero aluminum tensions.Keywords
Funding Information
- Centre for Energy Advancement through Technological Innovation
- ESBI
- University of Manchester
This publication has 37 references indexed in Scilit:
- Evaluating opportunities for increasing power capacity of existing overhead line systemsIET Generation, Transmission & Distribution, 2011
- Sound insulation property of wood–waste tire rubber compositeComposites Science and Technology, 2010
- Renewable energy strategies for sustainable developmentEnergy, 2007
- Vibration and sound radiation of sandwich beams with honeycomb truss coreJournal of Sound and Vibration, 2004
- Design of sandwich structures for concentrated loadingComposite Structures, 2001
- On the bending stiffness of transmission line conductorsIEEE Transactions on Power Delivery, 1997
- Wave propagation in and sound transmission through sandwich platesJournal of Sound and Vibration, 1990
- Statistical methods applied to Aeolian vibrations of overhead conductorsJournal of Sound and Vibration, 1987
- Estimation of conductor vibration amplitudes caused by aeolian vibrationJournal of Wind Engineering and Industrial Aerodynamics, 1983
- Forced non-linear vibrations of a damped sandwich beamJournal of Sound and Vibration, 1971