On the Adiabatic Shear Band Sensitivity of Extruded Ti-6Al-4V Alloy Under Dynamic Compression Along the Extrusion and Transverse Directions
Open Access
Abstract
Adiabatic shear banding (ASB) is a critical failure mechanism in titanium alloys subjected to high-strain-rate deformation, and its initiation is strongly influenced by the initial crystallographic texture. The dynamic response and ASB sensitivity of extruded and annealed Ti-6Al-4V (TC4) alloy rods were investigated under dynamic compression of cubic specimens along the extrusion direction (ED) and the transverse direction (TD) at a strain rate of 2500 s−1. Split Hopkinson pressure bar (SHPB) tests combined with digital image correlation (DIC) were employed to obtain the stress–strain response and the evolution of strain localization. A dislocation density-based crystal plasticity finite element model (CPFEM), incorporating the measured texture, was established to elucidate the correlation between texture and ASB behavior. The experimental results show that TD specimens exhibit a yield strength approximately 100 MPa higher than that of ED specimens, while both orientations display comparable post-yield hardening behavior. ASB initiation occurs earlier in TD (compressive strain ~0.13) than in ED (~0.23), indicating greater ASB sensitivity in the TD orientation. The CPFEM successfully reproduces the directional stress–strain responses and the observed localization morphology, enabling mechanistic interpretation in terms of slip activity and thermomechanical coupling. The simulations indicate that ED loading is dominated by prismatic ⟨a⟩ slip, resulting in lower flow stress and more dispersed strain localization. In contrast, TD loading is governed primarily by pyramidal ⟨c + a⟩ slip, leading to elevated flow stress and intensified localization. The higher ASB sensitivity in the TD orientation is therefore attributed to texture-controlled slip-mode partitioning, enhanced thermomechanical coupling, and a more concentrated crystallographic orientation distribution that facilitates intergranular slip transfer. These findings provide guidance for tailoring microtexture to mitigate dynamic failure in titanium alloys subjected to high-strain-rate loading.Keywords
Funding Information
- National Natural Science Foundation of China (12372362)
- Key Laboratory of Impact and Safety Engineering (Ningbo University), Ministry of Education (CJ202501)
This publication has 42 references indexed in Scilit:
- Direct measurement of critical resolved shear stress of prismatic and basal slip in polycrystalline Ti using high energy X-ray diffraction microscopyActa Materialia, 2017
- Microstructure evolution during warm working of Ti–6Al–4V with a colony-α microstructureActa Materialia, 2009
- Microstructural study of adiabatic shear bands formed in serrated chips during high-speed machining of hardened steelJournal of Materials Science, 2009
- A dislocation density based constitutive model for crystal plasticity FEM including geometrically necessary dislocationsActa Materialia, 2006
- A constitutive model for fcc single crystals based on dislocation densities and its application to uniaxial compression of aluminium single crystalsActa Materialia, 2004
- Effect of thermal conductivity on the initiation, growth and bandwidth of adiabatic shear bandsInternational Journal of Engineering Science, 1991
- The effect of strain rate, temperature and texture on anisotropic deformation in Ti-6Al-4VJournal of Materials Science, 1986
- The initiation and growth of adiabatic shear bandsInternational Journal of Plasticity, 1985
- Anisotropic continuum theory of lattice defectsProgress in Materials Science, 1980
- The identification of a Non‐Basal slip vector in titanium and Titanium‐Aluminum alloysPhysica Status Solidi (b), 1968