Effects of liquid properties on atomization and spray characteristics studied by planar two-photon fluorescence
Open Access
- 1 August 2022
- journal article
- conference paper
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (8) , 083305
Abstract
In this work, planar two-photon laser-induced fluorescence (2p-LIF) is applied for the first time to analyze the fluid dependent spray structure and atomization behavior of water and ethanol in a quantitative way. A commercial six-hole DISI (Direct-Injection Spark-Ignition) injector was studied at different injection pressures, operated with liquids containing the LIF dye fluorescein. Specifically for DISI-injectors, the fluid-dependent atomization is very complex and not fully understood due to the cavitating, turbulent nozzle flow that dominates the spray formation. Optical access and analysis of the near-nozzle spray are often challenging due to multiple light scattering in dense regions which is reduced by 2p-LIF measurements using a femtosecond laser. This allows high-contrast spray imaging close to the nozzle, resulting in an improved identification of single liquid structures of the spray. Thus, a higher accuracy of sizing is possible. Compared to water, the ethanol spray shape shows increased cone angles in the nozzle near-field of about 6%, which cannot be explained by classical atomization theory based on aerodynamic breakup. The larger cone angle of ethanol was attributed to its larger viscosity, which could decelerate the flow at the wall of the injection hole, affecting the velocity profile of the emerging jet. The atomization shows a main jet breakup distance of 7–10 mm in which the structure sizes decreased drastically, specifically for water. For the size of the liquid structures in the near-nozzle region, which show dimensions of about 80–130 μm, ethanol exhibited about 2% smaller Feret's diameters than water for the tested time steps at 20 MPa. This effect is even more distinct for other injection pressures and positions at a further distance to the injector. For all investigated conditions and measurement positions downstream of the nozzle, ethanol showed on average about 24% smaller structures compared to the water spray. Although this trend is in accordance with the classical atomization theory based on the aerodynamic breakup mechanism, other effects, such as cavitation and nozzle-flow induced breakup, contribute to this behavior.Keywords
Funding Information
- HORIZON EUROPE European Research Council (730871)
- HORIZON EUROPE European Research Council (638546)
This publication has 49 references indexed in Scilit:
- Quantitative imaging of a non-combusting diesel spray using structured laser illumination planar imagingApplied Physics B, 2012
- Quantitative optical techniques for dense sprays investigation: A surveyOptics and Lasers in Engineering, 2012
- Structure of evaporating single- and multicomponent fuel sprays for 2nd generation gasoline direct injectionFuel, 2011
- Physical modelling and advanced simulations of gas–liquid two-phase jet flows in atomization and spraysProgress in Energy and Combustion Science, 2010
- Vortex flow and cavitation in diesel injector nozzlesJournal of Fluid Mechanics, 2008
- High order conservative finite difference scheme for variable density low Mach number turbulent flowsJournal of Computational Physics, 2008
- Effects of cavitation in a nozzle on liquid jet atomizationInternational Journal of Heat and Mass Transfer, 2007
- The influence of cavitation on the internal flow and the spray characteristics in diesel injection nozzlesFuel, 2004
- PDA measurements of droplet size and mass flux in the three-dimensional atomisation region of water jet in air cross-flowExperiments in Fluids, 2000
- Combustion characteristics of water-in-oil emulsion dropletsCombustion and Flame, 1980