Impregnation of wood with a paraffinic phase change material for increasing heat capacity
Authors:
Open Access
- 25 October 2022
- journal article
- research article
- Published by Taylor & Francis in Wood Material Science & Engineering
- Vol. 18 (1) , 19-28
Abstract
In this contribution, the impregnation of wood with a paraffinic phase change material (PCM) is investigated, specifically to increase the heat capacity of solid wood, which significantly influences the thermal inertia when used in buildings. Four wood species (beech, poplar, oak and spruce) were impregnated with different pressure processes in an autoclave. For poplar, up to 480 kg of PCM per m³ of wood was deposited. For beech and spruce, also more than 200 kg of PCM per m³ of wood was achieved. However, oak was hard to impregnate and only about 100 kg of PCM per m³ was deposited. Leakage, which is undesired, occurred for all the wood species, especially for beech, but could be significantly reduced to less than 10% by increasing the viscosity of the PCM. The heat capacity was increased by one order of magnitude compared to clear wood, as measurements with differential scanning calorimetry showed. Simulations with an analytical model demonstrate the potential for damping temperature amplitudes in buildings in the summer month when applying PCM.Keywords
Funding Information
- Federal Ministry of Food and Agriculture (22014318)
This publication has 16 references indexed in Scilit:
- Thermal Characterization of Pinus radiata Wood Vacuum-Impregnated with OctadecaneEnergies, 2020
- Impregnation of Wood with Microencapsulated Bio-Based Phase Change Materials for High Thermal Mass Engineered Wood FlooringApplied Sciences, 2018
- Kinematic characterization of the pressure-dependent PCM impregnation process for radiata pine wood samplesEuropean Journal of Wood and Wood Products, 2018
- PCM/wood composite to store thermal energy in passive building envelopesIOP Conference Series: Materials Science and Engineering, 2017
- Lehrbuch der Bauphysik2017
- Fabrication and Properties of Polyethylene Glycol-Modified Wood Composite for Energy Storage and ConversionBioResources, 2016
- An Assessment of the PCM/Timber Composite in BuildingsKey Engineering Materials, 2014
- Modell und Programm CLIMT zur einfachen Ermittlung der Raumlufttemperatur und Raumluftfeuchte bei freier KlimatisierungBauphysik, 2010
- A review of materials, heat transfer and phase change problem formulation for latent heat thermal energy storage systems (LHTESS)Renewable and Sustainable Energy Reviews, 2010
- The absorption of phase change substances into commonly used building materialsSolar Energy Materials and Solar Cells, 1992