Effect of Metallic Coating Thickness on Stainless Steel and Carbon Steel Welded Plate Using Eddy Current Testing
Authors:
Open Access
- 1 May 2023
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 2467 (1)
Abstract
Over the last few decades, steel has seen a sharp increase in utilisation. Non-destructive testing (NDT) methods still face difficulties when attempting to identify corrosion behind coatings. One of these difficulties is the lift-off that complex structures bring. Because of the structure’s obstruction, corrosion goes undetected and can cause catastrophic breakdown. Additionally, lift-off effects lessen the sensitivity. On this paper the effect of coating thickness was measure by using metallic coating at carbon steel and stainless steel plates. The effect of coating thickness being identify based on measurement changes with different layer of coating thickness. From here the absolute and differential probe were used in measuring the lift-off because of coating thickness and the defect value. According on the result show that the Length of the crack at Toe, Root and Heat Affected Zone (HAZ) will reduce from 2.6% until 38.5% for carbon steel and 2.6% until 48.7% for stainless steel when the thickness of coating was increased. It different with Datum measurement where on carbon steel it increases from 0% until 11.5% and stainless steel 0.7% until 6%. Lastly the effect of coating thickness more effecting on defect measurement either carbon steel or stainless steel and artificial intelligent should be apply on each measurement for finding the right data getting in measurement as recommended.Keywords
This publication has 28 references indexed in Scilit:
- Design and Fabrication of Wearable Thermoelectric Generator Device for Heat HarvestingIEEE Robotics and Automation Letters, 2017
- Review on system development in eddy current testing and technique for defect classification and characterizationIET Circuits, Devices & Systems, 2017
- Metallic coating thickness assessment over nonmagnetic metals using apparent eddy current conductivity spectroscopyInternational Journal of Applied Electromagnetics and Mechanics, 2017
- An Efficient Modeling Technique for Analysis of AC Field Measurement Probe Output Signals to Improve Crack Detection and Sizing in Cylindrical Metallic StructuresJournal of Nondestructive Evaluation, 2015
- The Effect of Welding Residual Stress for Making Artificial Stress Corrosion Crack in the STS 304 PipeAdvances in Materials Science and Engineering, 2015
- Solution and Extension of a New Benchmark Problem for Eddy-Current Nondestructive TestingIEEE Transactions on Magnetics, 2015
- Investigations on a pulsed eddy current system for flaw detection using an encircling coil on a steel pipeInsight - Non-Destructive Testing and Condition Monitoring, 2014
- Thickness of coating tested nondestructively based on Welch frequency2014
- Coating Thickness Measurement2010
- Pulsed eddy-current measurement of a conducting coating on a magnetic metal plateMeasurement Science and Technology, 2002