A Comparative Study on Centrifugal Pump Designs and Two-Phase Flow Characteristic under Inlet Gas Entrainment Conditions
Open Access
Abstract
Capability for handling entrained gas is an important design consideration for centrifugal pumps used in petroleum, chemistry, nuclear applications. An experimental evaluation on their two phase performance is presented for two centrifugal pumps working under air-water mixture fluid conditions. The geometries of the two pumps are designed for the same flow rate and shut off head coefficient with the same impeller rotational speed. Overal pump performance and unsteady pressure pulsation information are obtained at different rotational speeds combined with various inlet air void fractions (α0) up to pump stop condition. As seen from the test results, pump 2 is able to deliver up to 10% two-phase mixtures before pump shut-off, whereas pump 1 is limited to 8%. In order to understand the physics of this flow phenomenon, a full three-dimensional unsteady Reynolds Average Navier-Stokes (3D-URANS) calculation using the Euler–Euler inhomogeneous method are carried out to study the two phase flow characteristics of the model pump after corresponding experimental verification. The internal flow characteristics inside the impeller and volute are physically described using the obtained air distribution, velocity streamline, vortex pattern and pressure pulsation results under different flow rates and inlet void fractions. Pump performances would deteriorate during pumping two-phase mixture fluid compared with single flow conditions due to the phase separating effect. Some physical explanation about performance improvements on handing maximum acceptable inlet two phase void fractions capability of centrifugal pumps are given.Keywords
Funding Information
- National Key R&D Program of China (2018YFC0810500)
- national natural foundation of China (51976079, 51779107)
- China Postdoctoral Science Foundation (2019M661745)
This publication has 24 references indexed in Scilit:
- Effects of flow pattern on hydraulic performance and energy conversion characterisation in a centrifugal pumpRenewable Energy, 2020
- Experimental Investigations on the Inner Flow Behavior of Centrifugal Pumps under Inlet Air-Water Two-Phase ConditionsEnergies, 2019
- A Review of Design Considerations of Centrifugal Pump Capability for Handling Inlet Gas-Liquid Two-Phase FlowsEnergies, 2019
- Investigation of the Motion of Bubbles in a Centrifugal Pump ImpellerJournal of Fluids Engineering, 2018
- Investigation on centrifugal pump performance degradation under air-water inlet two-phase flow conditionsLa Houille Blanche, 2018
- Application of gamma-ray computed tomography for the analysis of gas holdup distributions in centrifugal pumpsFlow Measurement and Instrumentation, 2015
- Experiments on Air-Water Two-Phase Flow Pump Impeller with Rotating-Stationary Circular Cascades and Recirculating Flow Holes.JSME International Journal Series B, 1996
- Investigation of Centrifugal Pump Performance Under Two-Phase Flow ConditionsJournal of Fluids Engineering, 1995
- Effects of Entrained Air on the Performance of Centrifugal Pumps : 2nd Report, Effects of number of bladesBulletin of JSME, 1974
- Effects of Entrained Air on the Performance of a Centrifugal Pump : 1st Report, Performance and Flow ConditionsBulletin of JSME, 1974