Effect of the Initial Texture, Recrystallization and Re-Dissolution Process on the Evolution of Texture during Solution Treatment of the 7A65 Hot Rolled Plate
Open Access
Abstract
The evolution of textures, the degree of recrystallization and the mechanical properties of 7A65 hot rolled plates during re-dissolution were studied with different thicknesses (25 mm, 65 mm, 120 mm) and different degrees of deformation. It was found that different plates exhibited different trends of re-dissolution because the degrees of deformation increased and the degrees of recrystallization were different during the solution treatment. With the increase of deformation and static recrystallization degrees, texture types changed from Cube, R-Cube to Brass, R, Cube and Copper during the re-dissolution process. The value of the Schmid factor was calculated and the value along the rolling direction was significantly larger than along the transverse direction, which led to a lower yield strength along the rolling direction. In terms of the average contribution of the yield strength, the strengthening of the grain boundary including LAGBs (low-angle grain boundaries) was found to play a more significant role than the effect of solid atoms and dislocation densities. Therefore, the 25 mm plate exhibits the best mechanical properties, with a yield strength of 565.7 MPa along the rolling direction.
Keywords
This publication has 30 references indexed in Scilit:
- Micro-mechanism of texture evolution during isochronal annealing of as-annealed hot rolled Al-Cu-Mg sheetMaterials & Design, 2019
- Microstructural evolution and strengthening mechanisms operating during cryogenic rolling of solutionized Al-Cu-Mg alloyMaterials Science and Engineering: A, 2019
- A Review of Texture Evolution Mechanisms During Deformation by Rolling in Aluminum AlloysJournal of Materials Engineering and Performance, 2018
- Mechanical behavior and texture development of over-aged and solution treated Al-Cu-Mg alloy during multi-directional forgingMaterials Characterization, 2018
- Effect of initial texture and microstructure of Mg on mechanical properties of Mg – Stainless steel laminated metal compositesMaterials Characterization, 2017
- Coupling of dislocations and precipitates: Impact on the mechanical behavior of ultrafine grained Al–Zn–Mg alloysActa Materialia, 2016
- Effect of heating rate on mechanical property, microstructure and texture evolution of Al–Mg–Si–Cu alloy during solution treatmentMaterials Science and Engineering: A, 2015
- Texture evolution in an Al–Cu alloy during equal channel angular pressing: the effect of starting microstructureJournal of Materials Science, 2011
- Evolution of microstructures and textures of 7050 Al alloy hot-rolled plate during staged solution heat-treatmentsJournal of Alloys and Compounds, 2010
- Controlling the textures of the Al alloy sheet via dissimilar channel angular pressingMaterials Science and Engineering: A, 2005